Electronics Forum | Wed Sep 23 08:29:19 EDT 2015 | tercel
Hi, I read about the problem "243 x drift adjustment no good" on a Philips CSM 60 (my type) and other machines of this type. I have the same problem but no manual for the machine to solve it. Do you still have the manual where the "Drift ajustment" i
Electronics Forum | Thu Sep 24 00:52:41 EDT 2015 | ermani9
Hi.. Move the XY arm to the center of the machine. Turn on the servo then immediately hold “LOWER” then press “ORIGIN”. You should see the message now on the screen “DRIFT CHECK”. The arm will start to drift without an emergency condition occurr
Used SMT Equipment | Pick and Place/Feeders
We have hundreds of feeders for Philips/Assembleon CSM 46 and CSM 60. 8 mm : 25 euro 12 mm: 45 euro 16 mm: 55 euro 24 mm pneumatic: 250 euro. Only few pcs. 32 mm pneumatic: 375 euro. Only few pcs. Nozzle 0603/0805/1206 for CSM46/60/84, new: €
Used SMT Equipment | Pick and Place/Feeders
This Philips CSM Eclipse Flexible Placement Machine, is left to right. The CSM Eclipse was made for fine pitch placement and smaller components down to 0402 size components. It is versatile and extremely good at a small runs and prototype application
Parts & Supplies | Chipshooters / Chip Mounters
Looking for parts to fit Philips/Assembleon CSM46/60. Chucks, belts, etc. We do not need feeders.
Parts & Supplies | Chipshooters / Chip Mounters
Below philips assembleon smt belts are manufactured in China,so no need to describe too much about price,what's the difference is that you will surely like it when you try them on machines,just based on the proved quality,please contact louis@smt-mac
20 MOhm voltage 250 Ohm current +/- 0.01 % Absolute accuracy error +/- 0.05 % of full scale +/- 0.1 % of full scale maximum Linearity error +/- 0.04 % Accuracy drift according to +/- 0.0025 % of full scale/â°C temperature Common mode rejectio
Career Center | Dargaha Road Zameen Pallavaram Chennai, Tamilnadu India | Maintenance,Technical Support
CURRENT JOB: • Responsible for four sub department as Production support, Preventive maintenance activity, Spare parts control and NPI (New product Introduction) under one Equipment department. • Take care of OEE (Overall Equipment Efficiency), MTTR
