New Equipment | Rework & Repair Equipment
BEST HeatShield Gel™ is a thermal shield water-based gel designed to be used in the PCB rework/repair or board assembly areas in order to provide thermal protection of electronic components. It is truly a revolutionary means to protect components. It
Electronics Forum | Thu Feb 03 07:39:24 EST 2005 | davef
The component orientation was just for the calculation. It has no affect on what you're seeing. As an alternate explanation, it's possible that difference in temperature is causing the board to flex in the z-direction [as you say, it may not be f
Electronics Forum | Fri Jun 06 06:11:18 EDT 2014 | paulg
I have a large monoblock ceramic filter on a PTFE based pcb material. The filter has a metal casing soldered onto the ceramic filter. I am concerned that if the heating rate is to rapid, then thermal shock / differential expansion could cause the fil
Industry News | 2012-05-23 14:18:26.0
Joint Industry Guideline Provides Best Practices for Measuring the Strain on Boards and Components During Manufacturing
Industry News | 2012-05-04 09:21:15.0
As printed boards evolve and chip speeds increase, the use of microwave technology in commercial applications, such as cell phone towers and in military products, is expanding.
Technical Library | 2023-11-27 18:19:40.0
This page introduces major causes and countermeasures of solder crack in MLCCs (Multilayer Ceramic Chip Capacitors). Major causes of solder cracks Solder cracks on MLCCs developed from severe usage conditions after going on the market and during manufacturing processes such as soldering. Applications and boards that specially require solder crack countermeasures Solder cracks occur mainly because of thermal fatigue due to thermal shock or temperature cycles or the use of lead-free solder, which is hard and fragile.
Technical Library | 2019-08-15 13:31:52.0
Cracks in ceramic chip capacitors can be introduced at any process step during surface mount assembly. Thermal shock has become a "pat" answer for all of these cracks, but about 75 to 80% originate from other sources. These sources include pick and place machine centering jaws, vacuum pick up bit, board depanelization, unwarping boards after soldering, test fixtures, connector insulation, final assembly, as well as defective components. Each source has a unique signature in the type of crack that it develops so that each can be identified as the source of error.
Technical Overview of Flex Mitigation Solutions News Forums SMT Equipment Company Directory Calendar Career Center Advertising About FREE Company Listing! Technical Overview of Flex Mitigation Solutions Flex cracks have been known
Technical Overview of Flex Mitigation Solutions News Forums SMT Equipment Company Directory Calendar Career Center Advertising About FREE Company Listing! Technical Overview of Flex Mitigation Solutions Flex cracks have been known
| http://etasmt.com/cc?ID=te_news_bulletin,23576&url=_print
Component Cracking-News-Reflow oven,SMT Reflow Soldering Oven-cmsadmin Reflow oven,SMT Reflow Soldering Oven 当前位置: Home >> News >> News Component Cracking Component Cracking Cracking of multilayer ceramic capacitors has been attributed to excessive heating rates during reflow
| https://www.eptac.com/soldertips/problems-with-stress-cracks-in-ceramic-components/
: Problems With Stress Cracks in Ceramic Components Question: We are having a problem with ceramic SMT components (CAPS) showing stress patterns and cracking after thermal testing
