Electronics Forum | Sat Mar 15 20:24:13 EST 2003 | ramanandkini
Thanks Mr.Dave. Sorry for the delay. One of our major prolems in ENIG plated surface is that wire does not stick. For many years we were getting a bond strength of 14 grams in both ENIG and electroplated surfaces. Now one vendor supplies ENIG boards
Electronics Forum | Mon Mar 03 10:38:28 EST 2003 | davef
Electroplated nickel and electroplated gold is the more �traditional� finish for aluminum wire bonding. That surface was an extension of gold thermosonic wire bonding that requires a thick [50 thou min] gold surface. For years fabricators recommend
Industry News | 2020-03-19 13:12:42.0
The SMTA is pleased to announce the Best Papers from SMTA International 2019. As speakers at SMTA International, individuals make contributions to the industry by sharing their research and findings. For these exceptional achievements, a cash award and plaque are given to primary authors of all winning papers.
Industry News | 2011-01-12 17:40:04.0
Check out these Show Highlights, Ways to Save, Networking and Educational Opportunities, and Exhibition Preview.
This video demonstrated the use of BEST Inc HotDots(TM) which allow wires to be affixed to the PCB or other surfaces-even when those surfaces go through reflow. There are other similar products out there but none of which can be readily customized no
Gold Wire Bonding Performance and Reliability of ENEPIG Surface Finishes Gold Wire Bonding Performance and Reliability of ENEPIG Surface Finishes The expression "multifunctional PCB", as a synonym for a PCB which is applicable with a variety
SMT Express, Volume 2, Issue No. 9 - from SMTnet.com Volume 2, Issue No. 9 Thursday, September 14, 2000 Featured Article Return to Front Page Book Review Reviewed by Dave Fish (davef ), Pandion Electronics, Inc Title: Wire Bonding
| https://www.eptac.com/blog/j-std-001-revision-changes-regarding-the-requirements-for-gold-plating-removal
. The initial reasoning behind the application of gold to printed circuit boards was to make them more susceptible to the application of wire bonding and for corrosion protection
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/advanced-technology-solutions/semiconductor
can be used to clean pads prior to wire bonding to improve bond strengths and yields. After wires are applied, they may be tested. Wire bonds can be over-molded or encapsulated for protection of the wire bonds. Nordson ASYMTEK Material Dispensing