Electronics Forum | Tue Jan 14 10:48:07 EST 2020 | dontfeedphils
I've worked with these quite a bit in the past as well. As the previous poster mentioned, we ran either 4/5 mil thick stencil with a pretty standard RTS profile in a 10 zone convention oven without issue.
Electronics Forum | Tue Jan 14 10:41:49 EST 2020 | robl
Hi Arnel, I've used these before but with a 0.005" stencil. The key issue here was that the pins are actually a solder preform at the base that melts into the board - sort of BGA like, so too much paste can cause issues. Samtec have some great app
Industry News | 2018-10-18 10:18:58.0
Case study: How to Create a Reflow Profile for a 16-layer, 2mm Thickness PCB with a High Density SMT Connector?
Industry News | 2015-01-27 13:31:03.0
Mentor Graphics and Key Industry Partners Align Analysis Tools, Methodologies, Models, and Reference Designs.
Connector Models - Are They Any Good? Connector Models - Are They Any Good? by: Jim Nadolny, Leon Wu; Samtec, Inc. Channel simulations are only as accurate as the models used to develop them. While we have seen much effort placed on printed
