The DispenseJet DJ-9500 supports a long list of jettable fluids for a wide range of applications. Incorporating over 15 years of jetting experience, the DJ-9500 jet provides even more capability than its DJ-9000 predecessor. Nordson ASYMTEK's jettin
Dispensers typically have some difficulty with maintaining a consistence dispensed volume over the entire syringe of material. Generally the dispensed volume drops as the volume of material decreases in a syringe. How serious a problem depends on fact
Electronics Forum | Wed Jul 07 13:33:45 EDT 1999 | Dave F
| who can tell me how viscosity measurements are really effective in smt process control? what can I monitor? Is it depending from fine pitch size? | Thanks a lot. | g. d'andrea | People write books on SMT process control. What's your problem? I
Electronics Forum | Sat Jul 10 00:57:17 EDT 1999 | Scott
| who can tell me how viscosity measurements are really effective in smt process control? what can I monitor? Is it depending from fine pitch size? | Thanks a lot. | g. d'andrea | The last place I worked used a viscosity meter, funny how little was
Industry News | 2012-11-29 17:15:16.0
Dispenser jets small, repeatable shot volumes for coating uniformity, accuracy, and reproducibility
Industry News | 2010-10-04 17:26:28.0
Industry-leading associations IPC and SMTA jointly announce the chairs of Workshop 2 of the High Performance Cleaning and Coating Conference, scheduled to take place November 16-18, 2010 at the Renaissance Hotel & Convention Center in Schaumburg, Illinois.
Precise coating discrete dots with the DispenseJet DJ-9500. http://www.nordsonasymtek.com
Introduction to the Unitech UC-250M-CV PCB Cleaner. Multi-stage in-line bare PCB surface cleaner. Brush/vacuum, rubber roller/sticky paper, & Ionized air blower.
| http://etasmt.com/cc?ID=te_news_bulletin,9161&url=_print
. In addition, if the viscosity of the solder paste is too low, and the solder paste slump is relatively poor, it is also a solder paste quality problem. (2
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/land-patterns-for-leadfree-componet-soldering_topic612_post2167.html
PCB design and manufacturing stage for that I don't think we need to modify complete pad structure. I am asking so much questions because in our organisation we have been facing soldering problem and we are suppose to resolve all the issues either it is at design stage or at manufacturing and we
