New Equipment | Rework & Repair Equipment
BEST HeatShield Gel™ is a thermal shield water-based gel designed to be used in the PCB rework/repair or board assembly areas in order to provide thermal protection of electronic components. It is truly a revolutionary means to protect components. It
New Equipment | Solder Materials
The Solder-Saver, from Aprotec: offers the opportunity to instantly recyle dross created in the solder pot. Hot dross is scooped up from the surface of the wave solder pot by the hand held, lightweight Solder-Saver. The unit separates dross oxides
Electronics Forum | Thu Oct 06 09:12:54 EDT 2005 | russ
in addition, your prints may have a larger volume from the reduction of scooping from the rubber blades.
Electronics Forum | Wed Sep 28 13:26:36 EDT 2005 | Jay Brower
Yes, I've used the muffin tins. I drained a solder drag pot. Steve makes a good point about the drain valve. When I drain my pot, I will be scooping out the solder and filling my tins.
Industry News | 2016-01-05 16:10:10.0
Novel method for protecting electronic components from heat.
Industry News | 2008-05-12 18:52:04.0
NASHVILLE � May 2008 � Kyzen Corp. proves once again why its are a world-leading provider of environmentally responsible precision cleaning products for the electronics industry as they scoop four coveted industry awards at two of the industries key global events:
Technical Library | 2018-03-07 22:41:05.0
This study investigates the scooping effect during solder paste printing as a function of aperture width, aperture length and squeegee pressure. The percent of the theoretical volume deposited depends on the PWB topography. A typical bimodal percent volume distribution is attributed to poor release apertures and large apertures, where scooping takes place, yielding percent volumes 100%. This printing experiment is done with a concomitant validation of the printing process using standard 3D Solder Paste Inspection (SPI) equipment.
Solder-Saver offers companies 'wave soldering' the opportunity to rapidly recycle dross created in the wave solder pot, thereby saving up to 50% in new solder bar purchases.
SMTnet Express, March 8, 2018, Subscribers: 31,288, Companies: 10,911, Users: 24,465 Optimization of Stencil Apertures to Compensate for Scooping During Printing Gabriel Briceno, Ph. D., Miguel Sepulveda; Qual-Pro Corporation This study
| https://ipcapexexpo.org/sponsors
& Fab Magazine Scoop Communications Signal Integrity Journal Silicon Semiconductor SMTconnect SMT Today SMT007 SMTnet U.S. Tech Wiring Harness News WNIE
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/adhesive-dispensing-systems/about-adhesives/news-search/nordson-supplies-izico-with-freedom-tankless-adhesive-system
. Thus, energy can be saved. In addition, the operator no longer has to fill the melter tank with pellets manually. At Izico, topping up the adhesive was reduced from throwing one scoop of adhesive into the tank ten times per production shift to filling the blue adhesive storage container with 20 kilogram sacks once a week
