Electronics Forum | Fri Dec 16 11:04:23 EST 2005 | chunks
Over all time will be dictated by your conveyor speed. Your conveyor speed will be dictated by your products time above liquidous. Time above liquidous is dictated by the manufacturers specification. Time and temp before reflow will have to be ach
Electronics Forum | Wed May 12 08:35:20 EDT 2004 | solderpro
yes this paste is a pain in the paste.... there are very few reasons for solderballs, component to pad ratio and placement.... solder paste control, using a mixer, not hand mixing, checking viscosity and temp..... or simply and bad profile and your
Industry News | 2009-09-17 15:08:48.0
GREELEY, CO —FCT Assembly announces that it will debut four new solder pastes and showcase its breakthrough UltraSlic™ FG solder paste stencil in booth 417 at the upcoming SMTA International conference & exhibition, scheduled to take place October 6-7, 2009 at The Town and Country Resort and Convention Center in San Diego.
.gif)
