Electronics Forum | Wed Aug 09 09:25:57 EDT 2006 | Mike F
Am I missing something here? I usually put some type of stiffener or support on the leading edge to make sure the PWB doesn't sag in the middle from the preheat. If I had to add a bean bag with shotgun pellets or BB's I would have boards falling out
Electronics Forum | Tue Feb 19 19:36:21 EST 2002 | davef
You weren�t clear but I assume the problem is not widely distributed and affects only a few parts on each board. Do this trick: * Cut a ~1� piece of fairly serious wire, like 18 or 12 AWG. * Strip the insulation. * Gear-up with gloves, glasses, and
Industry News | 2008-09-24 02:24:18.0
BALVE, GERMANY � September 2008 � Balver Zinn, a leading provider of high-quality anodes with various alloys as well as soft solders and special wires, announces the launch of an updated Web site, www.balverzinn.com, designed to enable complete interaction between supplier, customer, distributor and partner � anywhere in the world.
Industry News | 2008-11-03 23:20:34.0
BALVE, GERMANY � November 3, 2008 � Balver Zinn, a leading provider of high-quality solders in various alloys, anodes, solder wire, fluxes and pastes, announces the appointment of Holders Technology as distributor for its PCB Fabrication business in India.
| http://etasmt.com:9060/te_news_industry/2021-10-14/26961.chtml
: polyimide resin referred to as PI, appearance: transparent liquid, yellow powder, brown particles, amber particles polyimide resin liquid, polyimide resin solution, polyimide resin powder, polyimide Resin pellets, polyimide resin pellets
winsouce.jpg)