Electronics Forum | Mon Mar 05 11:04:14 EST 2007 | Yngwie
We are exploring ways to reduce the waste of solder paste. Here are some of the ideas I have in mind: 1) To use paste supplied in Syringe instead of jar. Paste that are opened more than 8 hours will normally be discarded, so we are looking for ways
Electronics Forum | Wed Nov 17 11:20:23 EST 1999 | Dave F
Hey Gyver: If you don�t mind (which you don�t have any choice about, because I�m going to do it anyhow, cause it�s MY word processor), I�m going to respond genericly, but still be directed to your question. Much of the following is paraphrased from
Industry News | 2018-12-08 03:24:24.0
RoHS Guide in Electronics: RoHS, WEEE and Lead-Free FAQ
Industry News | 2008-11-03 21:35:34.0
GREELEY, CO � October 2008 � FCT Solder, a division of FCT Assembly and an authorized Licensee of Nihon Superior Co. Ltd.'s SN100C product line, announces positive customer feedback concerning the performance of its NC601, WS101, and solid SN100C solder wires.
Technical Library | 2015-11-19 18:15:07.0
The move to lead free (Pb-free) electronics by the commercial industry has resulted in an increasing number of ball grid array components (BGAs) which are only available with Pb-free solder balls. The reliability of these devices is not well established when assembled using a standard tin-lead (SnPb) solder paste and reflow profile, known as a backward compatible process. Previous studies in processing mixed alloy solder joints have demonstrated the importance of using a reflow temperature high enough to achieve complete mixing of the SnPb solder paste with the Pb-free solder ball. Research has indicated that complete mixing can occur below the melting point of the Pb-free alloy and is dependent on a number of factors including solder ball composition, solder ball to solder paste ratio, and peak reflow times and temperatures. Increasing the lead content in the system enables full mixing of the solder joint with a reduced peak reflow temperature, however, previous research is conflicting regarding the effect that lead percentage has on solder joint reliability in this mixed alloy solder joint.
Lyra Reflow Oven is a soft soldering that realizes the mechanical and electrical connection between the solder ends of surface mount components or the pins and the printed board pads by remelting the solder paste pre-distributed on the printed board
SMT Express, Volume 3, Issue No. 5 - from SMTnet.com Volume 3, Issue No. 5 Thursday, May 17, 2001 Featured Article Return to Front Page Solder Paste Measurement: A Yield Improvement Strategy That Helps Improve Profits by Mike Riddle , ASC
to Front Page Solder Paste Measurement: A Yield Improvem
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/efd/resource-center/solder-glossary-of-terms
). Bridging Formation of a solder alloy connection between two or more adjacent contacts. Bumped Circuit Boards Bare printed circuit boards that have had solder paste deposited and reflowed on the pads prior to component installation
| https://www.eptac.com/soldertips/soldertips-issues-with-incomplete-solder-reflow-in-production-2/
. This would be related to percentage flux to metal ratio content of the paste rheology. As for the solder paste not reflowing and appearing as a solder ball grain structure on the surface of the solder paste, this is due lack of enough applied heat, which will prevent the solder paste
