Electronics Forum | Thu Dec 11 09:15:06 EST 2014 | sreejhu
Hello Sir, Thanks for your reply. i just got a mail from the DIMA service group and they said the Oven setting is as follows: Max temp settings in each zone (Which is not the temperature on your product, but close to where the air flow comes out of
Electronics Forum | Mon Dec 22 15:41:27 EST 2014 | benreben
why all people speak only the temperatur? the speed convoyor is very important too... with lesser zone of reflow you can lower the convoyor speed... but if i must speak about temperature and zone i think the minimum for solder all board in ROHS is 5
