Electronics Forum | Wed Nov 21 12:29:52 EST 2001 | mparker
Now that we know where you've been and what you wish to accomplish next, I can still give you some suggestions. 1. Get IPC-7912. Use it to evaluate your CM's. Especially if you have multiple contractors supplying like products. You will quickly see
Electronics Forum | Tue Dec 14 22:17:33 EST 1999 | Dave F
Armin: How ya doin� bud? CK gives good advice, but I'd like to take a bit of a different angle. Q1. For 0.7 mm (0.027in) diameter hole for vias, what�s the minimum annular ring for this hole diameter? Depends on what you�re trying to do. For in
Flux spray coating on a PCB with uniformal thickness down to 5 microns, with clear edge definition and minimal overspray. Can coat large or shoot dots with the same jet.
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/polymer-processing-systems/information/edi-hot-melt-coating-technology
Ideal for applications with a target coating thickness of 0.050mm (0.002") or greater and a coat wait tolerance of ±5% (with a backing roll) 45 ° lip adjustments (accessibility depending on die orientation
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/RSS_electronic-componentsresistor_topic2522.xml
), the temperature characteristics are not good, and the noise is usually large.Carbon Film Resistor mainly forms a carbon mixture film on the ceramic rod, for example, directly coating a layer, the thickness of the carbon film and the carbon concentration thereof can control the
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411