Electronics Forum | Tue Jun 17 07:17:09 EDT 2003 | James
The main problem I am having is getting the Rising slope 1-3 degrees. If I slow the conveyor down then I have too long of a reflow and if I speed it up then my ramp rate is too high. I was not sure if I need my first zones at a low temp or higher t
Electronics Forum | Tue Jun 24 06:58:53 EDT 2003 | sanjeevc
Hi The temprature for the first zone should be more as the PCB entering the oven from the ambient shop floor temprature needs a higher temp.Next zone could be lower than the first zone.The ramp is a relation of conveyor speed and the temp profile.T
Lewis & Clark | https://www.lewis-clark.com/product/isys-opto-in-pcb-for-ekra/
ISYS Bildverarbeitung ISYS Opto In PCB Rev.2 0051 L2 BOT - Lewis and Clark, Inc. Skip to content My Cart: $ 0.00 0 View Cart Checkout No products in the cart. Subtotal
Heller Industries Inc. | https://hellerindustries.com/browse/page/253/
&SPACER ASY,TOP PLD,ENT,836.2MM,MK3.6 443557---SPACER FOR FIREBAR,TOP,ENT,836.2MM,MK3.6 443558-01---COVER FOR FIXING FIREBAR,TOP,MK3.6 443558-02---COVER FOR FIXING FIREBAR,BOT,MK3.6 443559---FIREBAR
