Electronics Forum | Tue Jan 08 11:28:30 EST 2002 | mregalia
We use NC flux exclusively for SMT and wave soldering. And it is a fairly old formula from Multicore, though we are currently qualifying a new formula. The automated soldering does not appear to be a problem. It is only the hand soldering that causes
Electronics Forum | Thu Jun 08 17:13:41 EDT 2006 | davef
We don't agree that "a little to the top would just even things out". The raw flux on the top of the board never touches the wave and so, does not receive the proper amount of heat for activation, except at the through hole barrels. * We assume WML
SMT Express, Volume 2, Issue No. 6 - from SMTnet.com Volume 2, Issue No. 6 Wednesday, June 14, 2000 Featured Article Return to Front Page Process Control for Solder Flux Stacy KaliszMark OwenMVTechnology Ltd. ABSTRACT Flux used in ball grid
