Electronics Forum | Thu Oct 20 20:44:15 EDT 2011 | davef
Design based on: * IPC-SM-782A: Gap 0.0157", Pad 0.0354"X0.0276" [along gap] * IPC-SM-782A Mod used on 32411A1 & Volvo Smart Switch: Gap 0.0157", Pad 0.020"X0.020" [along gap] * IPC-7351: Gap 0.008", Pad 0.0256"X0.0256" [along gap]
Electronics Forum | Thu Aug 03 17:53:58 EDT 2017 | zsoden
That may just be an optical illusion. I've just measured and they're cut to just over 4mm (0.157"). The pot is at the level specified by the manufacturer (5mm from the bottom of the PCB if I remember correctly).
Electronics Forum | Tue Jun 03 06:29:43 EDT 2003 | mk
Orrrrrr, you could eliminate the printing, shorting, and special surface finishes by bringing the boards in with the paste already on them. There is a process that is a much more forgiving method for applying paste called solid solder deposit. Check
Electronics Forum | Thu Oct 11 22:25:50 EDT 2001 | davef
Bruce I�m with yall. Designers and fabricators say �pins�. You say: * BGA pins are 1mm [0.039�] pitch. * BGA pads are 0.4mm [0.0157�] diameter. * BGA pins are 0.6 mm [0.024�] side-to-side. * Board thickness is ~0.4 mm [0.015�] First, as you can
Electronics Forum | Thu May 04 04:47:28 EDT 2006 | rlackey
Hi Pat, Not going to change, but has changed. We were first notified about a potential change 2 years ago, but as we're such a volume user we could turn around and say no thanks. However as every one else has now changed over on commodity parts &
Electronics Forum | Thu Oct 11 17:44:30 EDT 2001 | aaelect
OK, OK. 672 ball BGA. The pcbs are PC Card bus size and are .015 thick. There are 3 on a panel with about 1/2" between and rails. The aluminum plates are about 3" by 7". There are 3 cutouts which allow for the parts from either side to protrude du
| 1 |
winsouce.jpg)
.gif)
