Electronics Forum | Tue Mar 03 12:36:14 EST 2020 | tomdegas
I cleaned and re-greased everything on the Hydra head and I even changed the motor and encoder and it still gives me the timeout error Z/156. Where do I look now? My machine has been down now for 3 weeks.
Electronics Forum | Thu Mar 05 07:40:55 EST 2020 | tomdegas
I swapped the mi boards with ones from a working My12 machine and the same results. To recap my problem: On "Hardware Initialization" the center jaws open and close, the Hydra Theta belt moves back and forth, the Hydra head moves all the way down an
Electronics Forum | Fri Aug 30 22:51:14 EDT 2013 | cvogel
IPC-J-STD-001E in regards to Ionic Cleanliness standards states less than 1.56 µg/cm² of total NaCL. Assuming a typical electronic process which involves smt, wave, and post-hand soldering and uses NO-Clean flux throughout all process, is it typi
Electronics Forum | Mon Aug 05 09:39:07 EDT 2019 | filipblad
Hi, I'm getting the F-MOT-MOVE X/156 error on our MY12 pick'n place. The manual tells me its an hardware issue. I found another thread on here where someone had a similar issue and they found out it was a power subbly issue. If I open the service pro
Electronics Forum | Fri Feb 21 10:50:00 EST 2020 | tomdegas
I am getting the following error on our MY9 during hardware initialization: F-MOT-MSEDYN HYDRA Z/156 Motor Timeout After the Theta test, The HYDRA head moves slowly all the way to the bottom and then moves slowly back up and the system fails initia
Electronics Forum | Thu Feb 17 22:08:19 EST 2000 | Dave F
Scott: I'll miss you, but there's no sense lettin' the blanks get you down. This is 'sposed to be fun!!! Good luck guy. Dave F
Electronics Forum | Wed Oct 09 16:43:50 EDT 2002 | mjz289
Kester 256 has also worked tremendously well for us. We have soldered thousands of BGAs from 156 balls to 780 balls .8mm pitch with no solder problems (shorts,opens or voids) and no residue problems. Give it a try.
Electronics Forum | Tue Aug 31 13:16:23 EDT 2004 | GS
Hi Davef, if by using Omegameter 600 SMD I am reading 1,56 microgram NaCL/sqcm, what is the real value I am measuring? considering the 14 sensitivity ?
Electronics Forum | Thu May 31 10:25:19 EDT 2012 | edmaya33
J-STD-001E, 8.3.6.2 states 1.56um/cm2 NaCl value.
Electronics Forum | Tue May 07 12:30:30 EDT 2013 | shankar2013
We are having a problem with our Mydata TP9-2U where the machine shuts down during a job with this message seen on the service monitor -- F-MOT1-26/156:MOVFI: MOTOR TIMEOUT Has anybody seen this problem?