Electronics Forum | Fri Oct 26 05:03:17 EDT 2018 | farouk225
Hi everybody, I have a question about the minimum distance to leave beteween a non non-plated mounting hole with copper pads and the edge of the PCB. Is there any formula or rule to apply ? For example for a hole of diamater equals to 5.6mm which
Electronics Forum | Fri Oct 26 13:16:41 EDT 2018 | slthomas
Is there any chance that something like a riv-nut might be used for mounting purposes or is it just a screw hole?
Electronics Forum | Fri Oct 26 12:29:22 EDT 2018 | davef
I'm not aware of a standard requirement. One screw hole diameter seems to used commonly.
Electronics Forum | Tue Dec 10 05:03:58 EST 2002 | praveen
We are having solder fillet finish issue. The solder looks like rough solder on the connector leads .The plating of the leads is Nickel (99.9% purity) and the PCB plating is imersion gold. I have tried fine tuning my reflow profiles an have used N2 i
Electronics Forum | Thu Apr 04 07:09:39 EDT 2013 | leemeyer
Autoprogram will use whatever tape feeder width is defined for that component (SMD type)and will adjust the pickup accordingly. Autoprogram will not tell you where to place Vibs and Matrix trays. You need to decide where to mount the holders. Then m
Electronics Forum | Wed Oct 08 11:18:41 EDT 2014 | wavemasterlarry
If its like my wave, the t-couple might not be mounted over a whole where the hot air blow out./ mounting it on the hot plate makes it over heat alot.
Electronics Forum | Fri Feb 28 01:36:43 EST 2020 | crystal12
> What is the use of gold plated boards? <BR> <BR> With the increasing integration of IC, the more IC the more dense. The vertical tin spray process is difficult to flatten the pads, which brings difficulty to the SMT mounting, and
Electronics Forum | Mon Mar 13 15:10:52 EST 2000 | Stuart Adams
Assuming agressive design rules what is the minimum distance I can get away with between the board edge and a SMT pad and between the board edge and a plated mounting hole ??? (The board is only 1"x2" and the mounting holes are 80 mil dia, 125 mil
Electronics Forum | Mon Mar 13 15:10:52 EST 2000 | Stuart Adams
Assuming agressive design rules what is the minimum distance I can get away with between the board edge and a SMT pad and between the board edge and a plated mounting hole ??? (The board is only 1"x2" and the mounting holes are 80 mil dia, 125 mil
Electronics Forum | Tue Jun 29 16:09:44 EDT 1999 | Dave F
| Could somebody tell me what means Leaching, ie: "Leaching of terminal end face exposing the ceramic"? | Roberto: Leaching, according to the SMTnet Library of Terms: Leaching. Dissolution of a metal coating into liquid solder. Nickel barrier unde