Electronics Forum | Thu Mar 30 01:06:46 EDT 2023 | erikfriesen
For anyone else looking at this, a normal startup runs a bit over 60A, but editing a running program can push this to 85A or so.
Electronics Forum | Wed Jun 21 17:54:20 EDT 2006 | russ
our 5 zone oven uses 220 and pulls 60A for startup. look at the spec sheets for your chosen oven and it will tell you current requirements Russ
Electronics Forum | Mon Jul 31 11:55:30 EDT 2006 | crissy
Mi Hard drive crash on reflow oven Model: 1500SX serial N.: 0699D-23579 480V 60A ,any help please.
Electronics Forum | Wed Jan 11 10:50:09 EST 2006 | beta
All, Current supplier of Solder bar charges for Pot Analysis to be carried out. �60 a go. They say that they get charged so they pass it on, With the imminent change over to leadfree this rule still applies. Anyone know of a Lab etc. in Ireland th
Electronics Forum | Fri Mar 24 15:08:20 EDT 2023 | erikfriesen
The nameplate specs for a 2004 Heller 1088EXL show 240V 60A, and specify Largest Heater Load of 25A. As each of the 8 heater elements is 6000W or 9.5R, how does this really work? Obviously all 8 elements on would pull 200A, so does the machine only
Electronics Forum | Thu Jan 16 15:16:52 EST 2003 | Mike Konrad
You are comparing apples to oranges. No-clean fluxes, because they are designed not to be cleaned off after reflow, contain very low solids. Normally, no-cleans have a solids content of 2% - 5%. Your basic RMA has a solids content of 15% to 30% (s
Electronics Forum | Tue Nov 27 20:19:12 EST 2007 | davef
Q1: How many mils the gap between the terminal and pad? A1: It depends on properties of the glue and z-force when the component is placed by the assembler. Q2: Your practice is for technology SMT-4? A2: We don't understand SMT4. We know that very sm
Electronics Forum | Sun Jan 17 19:21:06 EST 1999 | Wayne Bracy
To ALL: Guess I have indicated that I am not supportive of Trade Shows in general. Make it very clear that I do not support Nepcon West, East, Southwest, Philly, Japan, or UK. Of all of them I feel that there should only be Nepcon West. As for
Electronics Forum | Tue Jan 19 12:17:13 EST 1999 | marc p
| To ALL: | | Guess I have indicated that I am not supportive of Trade Shows in general. Make it very clear that I do not support Nepcon West, East, Southwest, Philly, Japan, or UK. Of all of them I feel that there should only be Nepcon West. |
1 |