Electronics Forum | Mon Jul 30 21:12:10 EDT 2012 | davef
We're seen components sticking to adhesive that was slobbered on the inside of cover tape.
Electronics Forum | Thu Jul 19 18:15:15 EDT 2012 | jil2000
We have a material that is been stick at cover tape, only 1 supplier is failing and only embossed tape packing is failing. A dark spots between tape and component are observed, we already bake material to se if is humidity, is not. We already apply
Electronics Forum | Sat Aug 18 23:03:07 EDT 2012 | eadthem
We have had this problem in the past, On paper tape resistors(old stock from before i took over and forced rotation on everything) and on embossed (national semi parts, strings of glue pulled back like seat belts across the pocket.) For the national
Electronics Forum | Thu May 04 10:14:31 EDT 2017 | sssvajunas
If 8mm component tape is cut off until components (no empty tape) how can I load it in to a ax feeder without throughing compoents?
Electronics Forum | Wed Feb 15 16:10:13 EST 2006 | slthomas
My understanding is that you get a reading that's the average of all of the jumped points if you jump tc wires with conductive tape. If you're doing multiple parts on a board with varying masses and don't control the attachment method (i.e., how mu
Electronics Forum | Fri Jan 15 09:55:58 EST 2016 | dyoungquist
Mycronic (Mydata) makes a solution for this. Product name is Tape Seal 8 or Tape Seal 1216 Tape Seal 8 - Part No: L-014-1600 Tape Seal 1216 - Part No: L-014-1572 I have used them and they work well.
Electronics Forum | Thu Jan 14 15:44:20 EST 2016 | sssvajunas
Hello, after we finish project (mydata) we unload tape from feeder and place a stick on the edge of tape. Maybe somebody can help with alternatives to this? (plastic clips) becouse then unloaded tape is used for another project it is sticky
Electronics Forum | Thu Mar 05 17:49:57 EST 2009 | snsmt
i have been looking for masking tape as well. I just came across esdtapes.com and got a sample of one of there tapes "CM300." I tested a component by taping it completely off and submerging it in water, just to see if it will soak through. The resu
Electronics Forum | Wed Feb 15 08:02:04 EST 2006 | davef
Se�or Tech Search the fine SMTnet Archives. For instance: http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=25210 Roger Saunders, President, Saunders Technology summarized the pros and cons of taping thermocouples as [He's taking about Ka
Electronics Forum | Thu Sep 26 16:29:02 EDT 2002 | pjc
Because most placement machine mfgs' feeders vary in width sizes its best to get the reference from them. Like how many 8mm slots does their 16mm consume, and so forth. Std. Sizes I've seen are: 8mm, 12mm, 16mm, 24mm, 32mm, 44mm, 56mm, 72mm, 88mm, 10
.gif)
