Electronics Forum | Wed May 27 10:26:35 EDT 2015 | jodonoghue
hi a long shot but i am looking for help trying to source a cable from a universal rad 5 sequencer . it is the cable that goes between the interupt sensor and the i/o box .. any help would be appreciated or help on where to look thanks in advance
Electronics Forum | Tue Feb 07 09:45:30 EST 2017 | rgduval
In a previous life, I ran ladder-racks for cable runs. Some of the vertical supports got a little tricky/limited any future movement of the line, but, that was a minor drawback. If you're running in the ceiling, they make cable hangars for the ladd
Electronics Forum | Tue Feb 07 08:13:58 EST 2017 | fuji_user_2014
Looking for recommendations on drop ceiling busway/raceway to neaten our cabling. It is intended for a surface mount line with varying power requirements, data/com lines, and air drops.
Electronics Forum | Tue Feb 07 10:18:34 EST 2017 | swag
Our entire shop floor has a hanging uni-strut grid ceiling approx. 10 feet up. The actual ceiling of the building is probably 16 ft. max ceiling with pitch. We run all air lines and power on it. The uni-strut is hung by all-thread rods. Sounds co
Electronics Forum | Wed May 27 15:48:21 EDT 2015 | alpha1
Do you have a part number we probably have it. Don Burshnick Alpha 1 Technologies
Electronics Forum | Wed Mar 02 13:13:55 EST 2005 | Dilbert
You can contact the manufacturer of the sensor, I don't think they would have anything but they may be able to give you some advice. Can you route the cable a different path away from other cables or objects creating noise?
Electronics Forum | Fri Jan 15 18:05:54 EST 2010 | rodrigo
Hi all, I'm looking for the cable pin-out to connect a PC serial port (9-pin) to an MCS30 serial port (9-pin). Can anyone help? Thanks
Electronics Forum | Wed Mar 02 05:02:46 EST 2005 | prabhu_jude
Hello, We are using a film piezo electric sensor to deduct and measure vibrations. A long twisted pair shielded cable is used to connect the sensor to the signal conditioning unit (the signal conditioning unit has to be kept at a distance from the se
Electronics Forum | Wed Mar 02 05:06:15 EST 2005 | prabhu_jude
Hello, We are using a film piezo electric sensor to deduct and measure vibrations. A long twisted pair shielded cable is used to connect the sensor to the signal conditioning unit (the signal conditioning unit has to be kept at a distance from the se
Electronics Forum | Thu Jan 03 22:39:37 EST 2002 | davef
For us, it depends on product volume: * Low volume: Tailor's scissors sharpened for the job. * Mid volume: Custom die used in a press. * High volume: We don't do this, but we'd have buy a singulation machine, er something like that. [Search the SMTne
