Electronics Forum | Fri May 04 01:34:07 EDT 2007 | dsd
Your Head 1&2 have Chucks, is Head 3 a Chuckless Head? The Chuckless Head or Precision Head is the intended Head for use with the Centering Station only. Using Head 1 & 2 is not good as there is too much nozzle play. In your Machine Configuration is
Electronics Forum | Fri May 04 02:32:10 EDT 2007 | jmelson
Thanks! Well, the procedure in the book says to first calibrate the mech aligner with the beam sensor, but that exceeds the X travel. I guess you can just eyeball it off the nozzles and then use trial and error. While poking around on the machine
| 1 |
.gif)
