Electronics Forum | Thu Sep 01 10:27:16 EDT 2005 | slthomas
OK, then, what's a good book to get that best covers lead free soldering? Is the one I mentioned a good choice? (still trying to figure out why that's such a difficult question)
Electronics Forum | Thu Sep 01 15:42:02 EDT 2005 | TomA
Steve, I have her book. Its a good book discussing the entire process. If you are looking for a book strictly discussing solders, then it would be too broad.
Electronics Forum | Thu Sep 01 11:18:16 EDT 2005 | patrickbruneel
Steve, Let me try to give you a short answer to your question. A good book in soft soldering would talk about the excellent characteristics of leaded alloys and all the reasons why leaded alloys are very reliable. In short a good book would advice y
Electronics Forum | Mon Apr 21 09:01:38 EDT 2003 | russ
Wave solder - Initially high cost but after that it is relatively cheap. Selective soldering with a solder pot such as the Air-Vac PCBRM models - Much lower cost than wave but if you get the right nozzles it is a great process. Solder preforms - s
Electronics Forum | Mon Apr 21 09:28:06 EDT 2003 | Bryan
What does acrinym---BNY mean? can't you use Paste In Hole process,if the pitch is large enough?You can find imformation about PIH everywhere. we have tried PIH,selective soldering,wave soldering,and found that wave soldering get the best solder joint
Electronics Forum | Wed Apr 23 18:06:23 EDT 2003 | jgregory
Grant, try TEKA solder-bearing connectors. They have a "brick" of solder that reflows during reflow. They work great! Jason Gregory
Electronics Forum | Mon Apr 21 06:26:28 EDT 2003 | Grant
Hi, We have a SMT production like, however we have very little experience with through hole assembly. We design everything to be completly SMT based, however connectors are the only part of our product that still requires through hole assembly. Cur
Electronics Forum | Wed Apr 23 19:24:29 EDT 2003 | MA/NY DDave
Hi Grant, You already have a few good answers. If you have but one to a few BNC connectors I would kind of use the advice here or do what you already are doing aka hand soldering. I would not install a Wave Solder line for a really low volume of BN
Electronics Forum | Wed Aug 27 08:25:24 EDT 2008 | davef
We'd expect to see: * Solder starved connections at pads with large trace/pad areas. * Less reliable solder connections at pads that do not match the shape and size of the corresponding pads on the component.
Electronics Forum | Wed Aug 27 00:20:38 EDT 2008 | rameshr
Dear davef, Will u pls advice what are all the possible defects caused while soldering ( assembling ) this type of boards.
.gif)
