Electronics Forum | Thu Oct 13 14:09:44 EDT 2005 | rcanten
If there is no option to send the proper data to the MTU it sounds like your line editor is configured incorrectly. You will still be able to send programs and the such but like you said you would never notice it until you had to send the proper back
Electronics Forum | Fri Jun 09 07:32:13 EDT 2017 | bukas
it sounds to me like a home sensor. try adjusting sensitivity if possible. move head manually to determine position at which home sensor is activated
Electronics Forum | Mon Jun 12 11:14:10 EDT 2017 | bobpan
Sounds to me like the z-encoder could be a problem. I cant remember but you may be able to disable a head in the system settings. Bob
Electronics Forum | Thu Jan 15 15:36:11 EST 2009 | babe7362000
Sounds like the driver card to me if it switched directions from the Y to the X when they swapped the boards
Electronics Forum | Tue Mar 02 04:30:32 EST 2010 | sigmaprint
Hi. It sounds like you may have the problem under control as you have ordered parts but if it still doesn't work please don't hesitate to contact us at sales@accuspares.com or visit our website http://www.accuspares.com. We should be able to help....
Electronics Forum | Wed Sep 04 12:55:51 EDT 2019 | dwl
Sounds like its just rejecting parts. Either the length and width of the component is wrong or the tolerance is set too tight. I don't remember the function codes to edit the tolerance but I left them at 30% (the max) and never had any problems with
Electronics Forum | Wed Sep 04 12:50:40 EDT 2019 | smrsteve
Thanks for that Steve - I'll try anything at the moment, but that sounds like a reasonable suggestion. I've already replaced a few cables that looked dodgy, and the LEDs on the LED rings, but I've not done a ribbon cable on the head yet. I shall hav
Electronics Forum | Wed Sep 04 14:12:26 EDT 2019 | bobpan
It sounds like the vac-verify is not working. There is a command on the hht to turn it off. When turning off your hht will show either 'idle' or enter command' without the V showing anymore. Maybe try the cntrl and vacuum or shift and vacuum. If its
Electronics Forum | Mon Feb 25 11:12:32 EST 2008 | hegemon
It sounds more as though you have a profiling problem primarily, however, if your placement is not square to the board, then you should get your machine setup correct first. After that you can get to the profiling. If the BGA is brought up to tempe
Electronics Forum | Tue Apr 21 13:28:23 EDT 2009 | cyber_wolf
Ha ! well Bruce it looks like great minds think alike. I have already tried everything you just listed. I really appreciate your input. Sounds like you know these machines well.