Electronics Forum | Fri May 03 19:02:41 EDT 2002 | davef
Several of the points you make are reinforced in the fine SMTnet Archives. Consider searching them for bedtime reading, until the responses start flowing.
Electronics Forum | Tue Jun 13 12:03:10 EDT 2000 | Chris May
Jason, If 225C is the topside temp of your board just prior to hitting the wave, I would say this is too high. Your flux suppliers data sheet should tell you an ideal topside temp for good flux activation, probably around 190C. According to the Bi
| Sm | t | net |
| 1 |
