GPD Global | https://www.gpd-global.com/pdf/pbt/Wafer-Option-PBFT-SPC98-PBT-3029.pdf
: a. Remove the bolts located below the Guide Mount (Item 20) to remove both the Pressure Wheel Assembly and the Tape Guide Assembly
GPD Global | https://www.gpd-global.com/co_website/pdf/lead-former/CF-8-Motor-Upgrade-Procedure-801-1-37.pdf
) motor bolts beneath the base plate Figure 4-2. CF-8 base plate A Base Plate B Motor Bolts b. Remove the motor bolts and set them aside for use during installing of the new motor. 3
GPD Global | https://www.gpd-global.com/pdf/lead-former/CF-8-Motor-Upgrade-Procedure-801-1-37.pdf
) motor bolts beneath the base plate Figure 4-2. CF-8 base plate A Base Plate B Motor Bolts b. Remove the motor bolts and set them aside for use during installing of the new motor. 3
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/polymer-processing-systems/products/dies/ultrasplit-on-line-die-separation-device
) for moving the flex die body back and forth mounting assemblies to permit pivoting of the upper die body To operate the system, first remove the body bolts and flip a switch to start the motor that
GPD Global | https://www.gpd-global.com/co_website/pdf/doc/Cyclops-Hardware-Upgrade-22290044M.pdf
: a. Carefully set the computer tower on its side with the Cyclops computer on top. b. Remove the three (3) bolts securing the side panel to the computer tower. c
GPD Global | https://www.gpd-global.com/pdf/doc/Cyclops-Hardware-Upgrade-22290044M.pdf
: a. Carefully set the computer tower on its side with the Cyclops computer on top. b. Remove the three (3) bolts securing the side panel to the computer tower. c
GPD Global | https://www.gpd-global.com/co_website/pdf/doc/Laser-Height-Sensor-22101449M.pdf
. While holding the height sensor so it does not fall, use a 7/64 Allen wrench to remove the two (2) bolts from the back of the Z-axis plate that secure the height sensor to the Z-axis plate. c
GPD Global | https://www.gpd-global.com/pdf/doc/Laser-Height-Sensor-22101449M.pdf
. While holding the height sensor so it does not fall, use a 7/64 Allen wrench to remove the two (2) bolts from the back of the Z-axis plate that secure the height sensor to the Z-axis plate. c
| https://www.eptac.com/faqs/ask-helena-leo/ask/defining-standard-industry-practices-for-torque-of-threaded-fasteners
things to printed board assembly processes. Torque is used in manufacturing of mechanical assemblies where parts have to be assembled together with hardware like nuts, bolts, screws and such
