Electronics Forum | Mon Feb 10 08:18:18 EST 2020 | astarotf
Hi We have an Accuflex MPM with camera vision problems which shows no image, only the screen looks gray. With the diagram we show that our MPM camera is receiving the appropriate 12V voltage on pin # 6 of the camera and supplies the video output on p
Electronics Forum | Wed Apr 07 21:49:44 EDT 2004 | Ken
My favorite kind of calibration is where the machine learns what it did incorrectly. Then fixes itself! However, there are many types of machines that rely on human feedback as to the results of what it did. nozzle calibrations involve many factors
Electronics Forum | Fri Dec 08 17:31:17 EST 2023 | madisreivik
Changed camera, flicker is gone. But cannot calibrate nozzle centers with the narrow camera, error all time I checked buffer image, brightness and contrast is SAME as with wide camera. Center of camera is roughly aligned using nozzle, its better
Electronics Forum | Fri Mar 05 12:24:34 EST 2021 | astarotf
Hello Our problem was the camera that was bad, we replaced it and it worked again, greetings!
Electronics Forum | Thu Mar 04 22:38:54 EST 2021 | tomek_k
Hi Miałem taki problem, myślałem też że to uszkodzona karta Cognex. Zakupiłem nową i to nie pomogło. Okazało się że trzeba zainstalować właściwy sterownik karty. (translate from PL) regards Tomek
Electronics Forum | Wed Dec 06 17:22:03 EST 2023 | madisreivik
Hello and help ! After changing oil hose, cleaning machine and all nozzles, CP642 narrow camera started to flicker. And in nozzle centering measuring, no image at all. We checked syncro pin, seems ok. Also checked camera picture with Sony monitor,
Electronics Forum | Mon Sep 02 15:20:48 EDT 2013 | aemery
Interesting! not the usual error. In my experience when the vision cables get damaged it shows up and white noise flashes across the monitor. The connections are the easiest to check so here's your system layout with connection points. Starting at
Electronics Forum | Mon Mar 04 19:05:44 EST 2013 | jaimebc
Deni, it is a 630 and there is text in the window, just no image of the component or anything else that is brought to the camera. It doesn't time out at all, it just moves the way it would when inspecting a component on test mode.
Electronics Forum | Sat Mar 09 16:14:41 EST 2013 | dilogic
Machine -> Configuration -> Parameters -> Setup then go to vision setup page, if available. - Dejan
Electronics Forum | Sun Sep 25 20:20:22 EDT 2011 | johnyq
We recently aquired an old MPM-AP25 stencil printer that printed paste with a large error (about .060 inches). I concluded camera alignment to be the cause but was surprised by the magnitude. I found the camera beam splitter prism misaligned and loos