Electronics Forum | Sat Feb 25 12:01:28 EST 2017 | ttheis
I'm setting up a asymtek millenium m-cob style dispenser for the first time and running through the master offsets routine but when it attempts to find the needle in the nsz needle sensor it works in the x direction but when it attempts to locate in
Electronics Forum | Sat Jul 16 07:46:17 EDT 2005 | davef
If you have a glob of epoxy on your board, it will be difficult to stencil you paste on that side. Dispensing paste may be a better choice.
Electronics Forum | Mon May 07 22:29:52 EDT 2001 | davef
4 wire per sec ... you figure how many you need] Encapsulation ~$120K for a dispenser [10 sec per die ... you figure how many you need] plus a cure oven ~$100k Throw in a another ~$100k for marking and cleaning Check the September 2000 SMTnet New
Electronics Forum | Tue Nov 05 06:51:59 EST 2002 | V.RAMANAND KINI
Hi, This is a widely discussed subject and since you have asked a brief explanation, I assume, you are a business man or a top executive in the company venturing in to COB. I waited to see if someone replies to you. May be it is a very old subject
1 |