Electronics Forum | Thu Sep 23 14:39:10 EDT 2010 | markgray
What is the exact message on the screen?
Electronics Forum | Mon Sep 20 06:29:27 EDT 2010 | darrenleebs
i have an old contact 3av pick and place machine that has started to display placement head position errors. the machine seems to start working if you switch it on and leave it for a couple of hours to warm up. has anybody had simillar issues with th
Electronics Forum | Thu Sep 23 11:37:43 EDT 2010 | flipit
I had 4 of these machines. They are good machines but I have seen this error often. Is the problem only on one head L or R? If so swap electronics L to R and see if it follows. You can even swap the Y motors. The items that could cause this prob
Electronics Forum | Fri Sep 24 16:01:07 EDT 2010 | dougt
I remember this problem but can't remember exactly what the reason was. It might have been the wrong pullup resistor on the MEI interface board used for the home photo on the y axis. You are right, after a couple hours the machine would work fine.
Electronics Forum | Fri Jan 30 16:49:21 EST 2004 | Mike Zadrejko, Videotek, Inc.
Barney, We currently have 3 Contact Systems machines, (1) C3AV and (2) C3AVXs and I can't say enough good things about the machines or the support. It has always, always been there since we started dealing with them in 1991. The Service Dept personn
Electronics Forum | Thu Dec 05 02:43:49 EST 2013 | haiae
Hi, You just take out motion board, clean it & connector on the interconnector board. After done plug in and boot the machine again, it'll be fine back.
Electronics Forum | Wed Dec 04 16:35:54 EST 2013 | martingruber
I am facing the following problem: Powering up the machine the start sequence stops with following message: Inizializing Hardware .... Reading SRAM data .... Inizializing MEI Motion Bd .... Mei bd. @ 240 # Dev. Version 2.4g2 Option 41 DSP BOOT MEMORY
Electronics Forum | Mon Dec 09 21:48:36 EST 2013 | haiae
Hi everyone, I have 2 contact systems machine, one 3av and one 3avx for 3 years. I still don't know how to do dry run mode for these machine. If anyone know how to do please kindly tell me. Many thanks,
Electronics Forum | Mon Jan 05 07:53:43 EST 2004 | pjc
This company provides third party service for Contact Systems machines: http://www.magellanservice.com/
Electronics Forum | Wed Feb 11 13:46:37 EST 2004 | fatally_phoenix
This company provides third party service for > Contact Systems machines: > > _a class=roll > href="http://www.magellanservice.com/" > target="_blank"_http://www.magellanservice.com/ _/ > a_ ------------------------------ Bob Tomecility at Mag