Electronics Forum | Fri Apr 27 09:41:44 EDT 2018 | cyber_wolf
Typically freezing and air conditioners equals a low charge.
Electronics Forum | Sat Mar 30 13:33:50 EDT 2019 | stephendo
This is not an HVAC unit. This is a small unit attached to a production machine to keep the solder paste from drying out prematurely or slumping. The volume of air being cooled and desicated would be less than 3 or 4 cubic meters.
Electronics Forum | Fri Apr 27 02:17:37 EDT 2018 | bukas
hello everyone, I have issue with one of my DEK air conditioners, it starts to freeze soon after we turn it on. most probable cause is low air flow or low refrigerant pressure. does anyone know what is operating refrigerant pressure range for DEK ai
Electronics Forum | Sat Mar 30 03:34:44 EDT 2019 | jacoblemaster
Are you still facing this issue? Well, I am so late to get to know this. I think you first check your evaporator coil if your air conditioner is still freezing up. It has been seen that a dirty airflow coil stops the proper flow of air through it. It
Electronics Forum | Wed Jun 26 13:42:14 EDT 2013 | nucleus
Hi, we just bought a used dek infinity 265. Unfortunately we cannot find a programming manual. We have two big technical references and a operator manual. Is there someone who has a pdf-version of the programming manual? Thanks! Best regards mts
Electronics Forum | Wed Jun 26 17:46:48 EDT 2013 | dman97
numeric values are input by pressing the / key.
Electronics Forum | Fri Mar 13 17:43:16 EDT 2015 | loganting
how helpful is it to use alignment weighting over fiducial offsets ?
Electronics Forum | Wed Jun 26 13:44:37 EDT 2013 | nucleus
by the way: How can I input numeric values by keyboard instead of pressing value +/- all the time? thanks!
Electronics Forum | Fri Mar 13 17:11:23 EDT 2015 | loganting
2 fiducial alignment vs 3 fiducial alignment , any opinion ? When do we actually need the third fiducial for alignment ?
Electronics Forum | Fri May 29 06:50:04 EDT 2015 | buckcho
Hello, can you explain better what do you want to check? Alignment is done based on fiducial check and then you can do some offsets, based on the print. So I am not sure what do you want to say...
