Electronics Forum | Wed Apr 19 20:33:14 EDT 2006 | davef
I just flew in from (insert city) and boy are my arms tired. pr: Likely, you're correct. The "pound-inch" units should have been the give-away, for us. Good catch. If this is the case, the frame fabricator would be the best source for tensioning
Electronics Forum | Sat Mar 30 13:33:50 EDT 2019 | stephendo
This is not an HVAC unit. This is a small unit attached to a production machine to keep the solder paste from drying out prematurely or slumping. The volume of air being cooled and desicated would be less than 3 or 4 cubic meters.
Electronics Forum | Tue Apr 18 19:48:08 EDT 2006 | davef
There is no standard, nor should there be [because the IPC standards should be aimed at describing results, not the path used to reach the results]. So, your printer equipment supplier recommendations are a good starting point. Your "35-46 lbs-in"
Electronics Forum | Sat Mar 30 03:34:44 EDT 2019 | jacoblemaster
Are you still facing this issue? Well, I am so late to get to know this. I think you first check your evaporator coil if your air conditioner is still freezing up. It has been seen that a dirty airflow coil stops the proper flow of air through it. It
Electronics Forum | Tue Apr 21 02:28:54 EDT 2015 | dinhhuunam
Juki GL-1.... Any thoughts? I'm New to the > industry and I'm trying to buy a new screen > printer. I have two in mind, DEK and Juki. Hi Sir, I'll advise you the SJ INNOTECH Vision Screen printer Best Solution & Service for You Model HP-520S Hi
Electronics Forum | Wed Sep 08 08:25:26 EDT 1999 | Brad Kendall
Listed below are the issues Viking has been experiencing since the | installation of the Proflow Head: | 1. After installing new 350mm Wiper foil with metal | strip glued on it, It worked for about a week and suddenly meta
Electronics Forum | Tue Sep 07 15:28:13 EDT 1999 | Earl Moon
Listed below are the issues Viking has been experiencing since the installation of the Proflow Head: 1. After installing new 350mm Wiper foil with metal strip glued on it, It worked for about a week and suddenly metal stri
Electronics Forum | Mon May 13 12:50:35 EDT 2019 | robl
Hi Spoiltforchoice, it depends on what you pay for the printers new, but last time I looked there wasn't much difference in price between the DEKs and the Speedprint if you were buying multiple units. Remember there is huge markups on SMT kit. From
Electronics Forum | Wed Jul 23 05:16:43 EDT 2014 | edriansyah
Hi All... Need your advice on the unit of measurement for solder paste pressure. My current company use SP machine from 2 vendor, both are using different unit of measurement. 1. Yamaha uom N 2. DEK uom Kg Up until now I dont know how to do
Electronics Forum | Tue Jan 12 19:07:07 EST 1999 | Earl Moon
| | For process management with SPC of the stencil printing process with a fully automatic stencil printer, what process outpur parameter would you recommend for SPC? | | | | It appears to me that there are two options: | | A: to have a pn chart bas