Electronics Forum | Wed Mar 17 04:26:44 EDT 2010 | mun4o
Hi, we have vitronics delta 6622 in your production.Problem with fluxer starting 3 weeks ago.Fluxer moving, but not spraing????I check flux system , and dont find any problems with machine.Clean the spray nozzle with compressed air , but nothing.may
Electronics Forum | Thu Oct 22 12:30:33 EDT 2020 | emeto
So is the initial motor at fault failing now or the one from zone 3?
Electronics Forum | Thu Mar 18 07:58:43 EDT 2010 | mun4o
It is a pressurized system, and , Yes , there are a message "No flow nozzle 1".Our machine have not 'ShoRate' gauge at the back of the machine.There are only 3 gauge for flow on the front side , like watch ???
Electronics Forum | Wed Oct 21 13:50:50 EDT 2020 | kierantennant
hi, I am experiencing a problem with our wave solder machine where zone 2 (forced convection) fan will not work when called upon. so we swapped it with zone 3 to make sure the motor was not at fault and it wasn't so we moved the A1 into a different 2
Electronics Forum | Wed May 19 07:38:42 EDT 2004 | Bob L.
I'm trying to help one of our remote sites solve a problem with a warped PBGA. The corners are lifted, creating columnar joints and the central balls are sometimes shorting. I've verified that it's not popcorning and I've got samples going to the l
Electronics Forum | Fri Sep 14 08:53:43 EDT 2012 | mbnetto
Hi, Recently we acquired a Delta 3 and I noticed everytime we change any value regarding to the tracking system, as chip or main wave - offtime/ontime- with boards loaded on it, the tracking system doesnt work well. sometimes it turns off the wave o
Electronics Forum | Fri Sep 14 10:53:25 EDT 2012 | mili
In Setup menu there is a last option Debug. Debug choosing a window with Rack0, Rack1, Rack2, Rack3, log RS485 opens. Choosing rack0 a window with parameters S3 boxes 1 to 12 Input and certain boxes are checked, S4 Output from 1-8, from 1-8 S5 Outpu
Electronics Forum | Fri Sep 14 03:43:16 EDT 2012 | mili
Hello!I have a delta wave with these problems:offtime of lambda wave tracking is too long and when modify offtime setting to a negative value for a fast stop on tracking position of lambda wave, the wave pass on stand-by with a delay of half of leg
Electronics Forum | Mon Apr 09 09:39:40 EDT 2018 | justconmac
Having an issue with tracking for the Vitronics Soltec Delta 3. Wave will not give error on "expected PCB at exit" but will still show 1+ pcb's in the wave when the machine is empty. This is causing solder pump to idle unnecessarily. Outfeed sensor i
Electronics Forum | Wed Jul 18 21:58:38 EDT 2018 | ir11
Hi There... Sorry to post another query here but I have an existing line for pick & place machine using FUJI NXT II M6 Generation 1. We would like to add NXT modules but then the available modules that we have now is NXT III Generation 3. Is it pos