Electronics Forum | Thu Oct 22 12:30:33 EDT 2020 | emeto
So is the initial motor at fault failing now or the one from zone 3?
Electronics Forum | Wed Oct 21 13:50:50 EDT 2020 | kierantennant
hi, I am experiencing a problem with our wave solder machine where zone 2 (forced convection) fan will not work when called upon. so we swapped it with zone 3 to make sure the motor was not at fault and it wasn't so we moved the A1 into a different 2
Electronics Forum | Tue Sep 15 13:02:55 EDT 2009 | horvath83
What do you think about optimal setup for 8-hour working shift and 16-hour standby time. What is the most energy efficient setup for standby time? Complete cooldown or maintaining temperature in solder pot?
Electronics Forum | Wed Sep 16 09:04:12 EDT 2009 | stepheniii
All the heat that comes off the machine comes from powering the machine. The more heat that comes off it, the more energy that went into the machine. When the machine is cold there is no heat energy leaving the machine. Therefore complete cooldown
Electronics Forum | Wed Sep 16 09:29:47 EDT 2009 | patrickbruneel
There has been a thread on the subject in 2007 with record postings. Check here: http://www.smtnet.com/Forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=11796&#Message50533
Electronics Forum | Thu Jun 28 18:50:08 EDT 2018 | caurbach
We don't have your exact machine or know your exact configuration, but our machine has occasionally gotten an estop due to a breaker in the SelectX tripping. Just be aware that there are circuits other than the mushroom switches that can generate an
Electronics Forum | Tue Jun 13 18:41:12 EDT 2006 | grantp
Hi, Is it possible to have too much flux? Grant
Electronics Forum | Tue Jun 13 19:00:17 EDT 2006 | Hoss
Samir's ICT guy says YES.
Electronics Forum | Thu Jun 25 09:52:06 EDT 2015 | byviko
Hello, we will buy new wave soldering machine . Trying to decide between two model; Soltec Delta-x and ERSA Powerflow N2. Could you help us , which one is better? most of pcb low volume, others high volume. At first low batch production will be done
Electronics Forum | Mon Apr 09 09:39:40 EDT 2018 | justconmac
Having an issue with tracking for the Vitronics Soltec Delta 3. Wave will not give error on "expected PCB at exit" but will still show 1+ pcb's in the wave when the machine is empty. This is causing solder pump to idle unnecessarily. Outfeed sensor i
winsouce.jpg)