Electronics Forum | Tue Nov 03 18:56:22 EST 2020 | goldendragon
All, I'd like to know what a good used wave pb-free solder machine out there? Appreciates!
Electronics Forum | Mon May 16 15:22:54 EDT 2005 | Fred N
the company i work for is going into circuit boards and want to find a used wave solder machine theyre budget is 10 to 20 k i have never run one of these machines and dont no what to look for anybody out there have recommendations of what i
Electronics Forum | Mon May 16 15:33:52 EDT 2005 | jasont
Hi Fred, Will you consider used waver solders? I wills end you a list of pre-owned, good working waves that we have in stock. Regards, Jason
Electronics Forum | Mon May 16 16:40:50 EDT 2005 | russ
Fred, give us a quickie at what you will be soldering Single sided thu hole, double sided SMT, both, lead pitches and protrusions, Flux type, and such. Buying a used wave can be tricky and the more info up front the better we will be able to tell yo
Electronics Forum | Tue May 17 10:28:29 EDT 2005 | tds
What state are you located in?
Electronics Forum | Tue May 17 10:34:11 EDT 2005 | Fred N.
located in central Montana
Electronics Forum | Tue May 17 10:11:54 EDT 2005 | russ
I would use a foam fluxer since spraying rosin will make the stickiest nastiest mess you can imagine. 18 layer board huh? You will want convection preheat, both top and bottom preheaters, preheat tunnel of at least 4-5', a chip wave, laminar flow w
Electronics Forum | Mon May 16 18:03:30 EDT 2005 | davef
Key Issue: Will this machine solder your boards? You never know until you solder one. Any other avenues of analysis involve substantial risk. Flux Selection * High or low solids * VOC or VOC-free Solder Alloy * If using lead-free, avoid stainles
Electronics Forum | Mon May 16 16:34:02 EDT 2005 | Fred N
Jason, thx for the reply am definitly looking at used, but was hoping someone would log on to tell me what I should be looking for since i no nothing about the subject.
.gif)
