Electronics Forum | Tue Mar 06 08:33:40 EST 2007 | cardinal
You can get a topside edge-clamping system to fit your AP HI E printer from Gridlok. They make a universal tooling system and topside edgeclamping system for the AP series and UP 2000 series printers. The Y snugger tooling option when ordered with t
Electronics Forum | Wed Nov 13 23:50:23 EST 2002 | iman
we changed our top/bottom clamping system in the Printer, to a side-edge clamping system. This removed the higher paste issue similar to your thread.
Electronics Forum | Thu Nov 15 12:07:08 EST 2001 | mgillespie
Although this is a old message, I would like to add that DEK do offer a edge clamping option on ALL 265 class machines, thereby removing those sharp edges from the machine. Regards Mark.
Electronics Forum | Tue Oct 13 16:26:26 EDT 1998 | Earl Moon
| | We suffered our first blood letting because of razor sharp edge clamps (DEK 265LT) and operator giving it the finger. While positioning magnetic tooling pins, one of our best slipped and really sliced off a part of his main digit. This will impac
Electronics Forum | Wed Jul 11 13:34:57 EDT 2007 | pauld
Thanks Pete, I have plenty of Omega thermocouple leads on hand. By the way ECD is the mfg asking $989 for a probe that costs about $100, to which they add a pcb edge clamp.
Electronics Forum | Thu Aug 12 14:17:19 EDT 2010 | mikesewell
You might reduce your panel size, cut it in half and rotate to better utilize your edge clamping/board supports. Tape off your current stencil and see if it improves the print. A new stencil and a little extra handling may be cheaper than tooling.
Electronics Forum | Thu Dec 16 06:06:52 EST 1999 | Stefan
Check the print gap and check the clamp edges, sometimes the clamps is damaged causing a distance between the PCB and the screen. Good luck
Electronics Forum | Mon Sep 17 09:44:29 EDT 2001 | gresko
Dave, Ceramic sheets of that size are not always flat and as a result will sometimes crack when clamped along the full edge. Point clamping will hold the substrate secure for placement. If you are not processing in a pallet make sure that you have
Electronics Forum | Fri Oct 24 13:00:36 EDT 2014 | markhoch
I'd check into the ASYS LSB-03 Bareboard Destacker. It isn't a gravity drop style. It uses edge clamps to clamp the top PCB on the stack and then drop it on the transport rail. So it doens't destack from bottom to top, it destacks from top down. We
Electronics Forum | Tue Oct 13 09:08:54 EDT 1998 | Earl Moon
We suffered our first blood letting because of razor sharp edge clamps (DEK 265LT) and operator giving it the finger. While positioning magnetic tooling pins, one of our best slipped and really sliced off a part of his main digit. This will impact hi