Electronics Forum | Tue Jun 25 10:36:10 EDT 2002 | Vincent Balboni
Do you have a fixed number of components that you write off each time a feeder is loaded.
Electronics Forum | Tue Jun 25 11:26:11 EDT 2002 | pdt203
Sometimes when a customer has sent parts on reel without any leader, we will take out the first 5-8 parts and then tie off the cover tape with some leftover tape from the last run. We keep those parts we removed and then place them back in the feede
Electronics Forum | Tue Feb 15 10:21:19 EST 2005 | gregp
Any tape--any pitch. On our C5 platform every part number (in your database) has a package type assigned to it. The package type contains the information about the pitch and component orientation. When you load the feeder you scan the part number-
Electronics Forum | Tue Feb 06 10:55:58 EST 2001 | pjc
Larry, Our specification is 0.075% for our Fuji CP3 and IP2 machines. At or above that figure the Maintenance Dept. has to get to work. We typically see 0.03% to 0.05% on average. The Fuji machines are all vision centering. We have found feeders are
Electronics Forum | Tue Mar 30 10:57:54 EST 1999 | Steve Gregory
Hello, I'm a student assistant in a research project that deals with the simulation of PCB assembly systems. At the moment I collect information about SMDs. My problem is how to assign the correct feeder width to various devices in a simulation. Is
Electronics Forum | Tue Apr 03 06:08:11 EDT 2012 | rpa
Hi, where can i place a manual tray feeder on OPAL XII - Assembleon. I tried to put the tray on rear side feeders positions and teached components array positions but an error occurred "software outlimits".
Electronics Forum | Tue Apr 03 08:34:38 EDT 2012 | thanh
REAR, NEXT TO TABLE UP AND DOWN. CHANGE FEEDER SET UP TO FIX TRAY. MAKE SURE YOU HAVE CORRECT NUMBER OF X,Y COMPONENTS IN TRAY AND NUMBER OF TRAY FOR THE PART.
Electronics Forum | Sat Feb 02 04:48:30 EST 2019 | dfl
yes it's moving at the wrong pitch, about 3 components a time. Is the programming you talking about at the microcontroller AT85C55 or that serial memory 24C04? Or there is some procedure on the Quad to adjust this?
Electronics Forum | Sun Feb 03 07:39:27 EST 2019 | dfl
POCKET POSITION PROGRAMMING This procedure ensures the components are properly centered at the tape feeder pickup point (over spring stabilizer). NOTE: The feeder can be reset at any time by removing it from the feeder base and reinserting it. This
Electronics Forum | Tue Mar 04 11:20:56 EST 2008 | wayne123
I am unfamiliar with the Philips Saphire. I am needing to know if the feeders That work on our Topaz and Emerald will also work on a Saphire. I assume that they would just because the feeders are being sold as "Gem" feeders. In addition, Is anyone a
Manufacturer of PCB depaneling and PCB soldering machines since 2005, products include CE approval V-groove PCB depanelizer, PCB router, PCB punching machine, laser depaneling, hot bar soldering machines and soldering robots.
Liwu Industrial Park, Yuanzhou Town, Boluo
Huizhou, 30 China
Phone: +86-138-29839112
.gif)
winsouce.jpg)
