Electronics Forum | Tue Oct 24 19:09:12 EDT 2023 | sarason
Possibly blocked air lines did you check air pressure? Also drivers on the relevant boards. or simply damage in the flexible wiring harness( a nightmare) sarason
Electronics Forum | Fri Oct 13 19:01:46 EDT 2023 | crystalw4280
I have an old Juki 2060 The electors were replaced on some heads that were disabled. Now we are showing some of the same errors with those heads. Does anyone have any suggestions for possible cause that would make this happen again. Another warning
Electronics Forum | Tue May 26 10:52:02 EDT 2020 | spoiltforchoice
No idea, could be a weird translation error, but its certainly something I have seen . For an FLX they just ask for this "5-6 bar, clean, dry, oil free, filtered 2 µm, connection diameter 8 mm", 40litre/min Personally I would go with a mo
Electronics Forum | Wed Dec 03 06:04:10 EST 2014 | spoiltforchoice
Manual placement aids are often very similar, I would suggest it is quite difficult to tell them all apart. Most of them include some kind of carousel for bins of loose parts and have the option of a few tape "feeders". If you are building small volu
Electronics Forum | Wed Oct 17 09:19:23 EDT 2007 | actech
This box has the I/O card mounted sideways under it's own cover on the side of the main box. The CPU card is the bottom card. The Two driver cards X/Y and R/Z are side by side and mount to a steel base pannel with there relays at the back. but even i
Electronics Forum | Sat Aug 07 11:33:55 EDT 1999 | JohnW
| | What oven temperature should be used to reflow solder (Sn63Pb37) on a PC board (0.075" to 0.100" thickness) in 5 to 10 minutes? | | Profiling - tedious but important. As said, start with the paste manufacturers recomendation which is usually pu
Electronics Forum | Mon Jun 25 20:47:09 EDT 2001 | davef
Much of the focus of pick & place machine supplier development efforts seems to directed towards either: * Head location detection, adjustment, and control. OR * Component location prior to pick-up. OR * Component position error correction after pick
Electronics Forum | Sat Oct 02 03:27:52 EDT 1999 | Brian
| I am currently in the middle of a company wide war and I'm looking for data (AMMO). Here are the problems: | | 1) I am looking for anyone who has done or seen any reports on Thermal Shock to smt parts and/or via holes caused by Soldering Irons at
Electronics Forum | Sun Aug 08 20:59:55 EDT 1999 | Dreamsniper
| | | What oven temperature should be used to reflow solder (Sn63Pb37) on a PC board (0.075" to 0.100" thickness) in 5 to 10 minutes? | | | | Profiling - tedious but important. As said, start with the paste manufacturers recomendation which is usua
Electronics Forum | Sat Oct 02 20:19:19 EDT 1999 | John Dwinell
| | I am currently in the middle of a company wide war and I'm looking for data (AMMO). Here are the problems: | | | | 1) I am looking for anyone who has done or seen any reports on Thermal Shock to smt parts and/or via holes caused by Soldering Ir
