Electronics Forum | Mon Dec 11 14:09:58 EST 2017 | deanm
Some pick and place machine manufacturers offer dual lane feeders which may double the machine's feeder capacity. What are the pros/cons of using dual lane feeders in a high mix environment? Are they just for 8mm? Thanks!
Electronics Forum | Tue Dec 12 12:03:39 EST 2017 | dleeper
A lot of it depends on what machines you are using and how well they implement dual lane feeders. A few general comparisons: Pros: -You can fit more feeders on your machines. -One dual lane feeder is cheaper than two single lane feeders Cons: -two
Electronics Forum | Tue Dec 12 03:21:02 EST 2017 | tsvetan
I would stay away from dual line feeders. They make change overs hell. Each new board need much more time to re-locate the components on the feeders as you need to re-load them again instead to just move the feeder with loaded reel on new position.
Electronics Forum | Wed Dec 13 22:22:04 EST 2017 | deanm
As mentioned above, Mycronic and Europlacer seem to be designed toward high mix so would consider them but would also like to consider a more traditional machine too. Right now I have around 220 feeder slots across two machines inline. Mycronic and E
Electronics Forum | Wed Dec 13 01:14:02 EST 2017 | tsvetan
"Pros: -You can fit more feeders on your machines. -One dual lane feeder is cheaper than two single lane feeders" none of these is true for Sony SI-G200 machines we have dual lane feeders are bigger than the standard 8 mm feeders so no space savin
Electronics Forum | Tue Dec 12 11:46:50 EST 2017 | emeto
Single feeders will always be your top choice. Any kind of package feeders will create issues in future. I used to have them in 10s, 8ths, 6es, 3s, 2s and the more they are the worst.
Electronics Forum | Mon Dec 11 19:28:51 EST 2017 | spoiltforchoice
That's not really the point of dual lane feeders. As a general rule having a dual lane 8mm feeder means the machines "slots" are actually 16mm, dual lanes on a 8mm feeder helps keep the overall lane density of a machine higher, its much easier to bui
Electronics Forum | Wed Dec 13 11:02:15 EST 2017 | dleeper
DeanM, What make/model of machines are you considering? As is evident by the feedback, your mileage varies greatly depending on who's' machines your using.
Electronics Forum | Tue Dec 12 17:34:39 EST 2017 | spoiltforchoice
A pattern emerges, but really I think it means plan/optimise for your day/week not a single job. Our machine uses 10's, this means there's a significant chunk of the feeder that is not easily accessible if something like a brass shim gets stuck or f
Electronics Forum | Wed Dec 13 08:25:37 EST 2017 | emeto
Another aspect is the maintenance and repair of the feeders. When a bank of 10 feeders goes bad, you lose 10 positions right away. Even if you have spares, now you have to move 10 parts instead of 1. Very often you will have only one bad slot, and no