Electronics Forum | Thu Oct 04 00:03:28 EDT 2018 | gaintstar
flason smt pick and place machine: http://www.flason-smt.com/product/Hanwha-IC-placer-SM321-High-Speed-SMT-Modular-Chip-Mounter.html http://www.flason-smt.com/product/Hanwha-Pick-and-Place-Machine-DECAN-F2-High-Speed-SMT-Modular-Chip-Mounter.html htt
Electronics Forum | Tue Jul 30 04:01:14 EDT 2019 | SMTA-David
Thanks all for your replies. I ended up getting an older second hand machine (2003 Heller 1707 EXL) from a local company upgrading their assembly line. It is in mint conditions and was used in air conditioned room and had maintenance every 3 months.
Electronics Forum | Tue Aug 13 09:41:03 EDT 2013 | horchak
If it's forced air convection I'd check all the circulating fans and filters. Also if its a clam shell bonnet make sure it's closed all the way and the seal is good. You didn't specify whether it is one zone or the full length of the oven, I do not w
Electronics Forum | Tue Aug 13 10:22:13 EDT 2013 | mccabekev
We are seeing this the full length of the oven. We run a lot of double sided boards, so we cannot run them on the wire mesh. I checked inside the oven to ensure there was no build up of dropped parts that could block it. The temperature difference
Electronics Forum | Wed Aug 14 18:19:09 EDT 2013 | jlawson
Generally the heller exl range has issues in cross profile, some machines more than others. I have see as bad as 15 deg c and as low as 5 deg c ranging from entire length to a few zones. They never match the specification in reality. The markiii is
Electronics Forum | Tue Aug 13 10:09:10 EDT 2013 | dyoungquist
We have a Heller 1707EXL that we use for lead and lead-free production. It has both a mesh belt and edge rails. We run 90% of our assemblies on the mesh belt (leaving the edge rails wide open). I have noticed when profiling a board on the mesh bel
Electronics Forum | Wed Aug 14 13:39:59 EDT 2013 | eadthem
Most of this you have probably covered, but these are what have caused heating issues for us in our 1707 EXL. First, you would probably notice, but check that all blowers are turning by looking at there cooling fans in the top and bottom, Our 170
Electronics Forum | Thu Jul 23 13:23:45 EDT 2020 | bmalhi
Small components blown issue could be due to one of the below. - Process issue; Make sure solder paste is fresh, if flux is drying out it will not hold parts properly. Check downward pressure of Pick Place. SOT may have to be pushed a little harder i
Electronics Forum | Tue Nov 13 00:05:11 EST 2012 | eadthem
Typical problems with our heller 1707 EXL would be blower issues. We have almost replaced every blower on the top sense purchase. Fortunately Heller is very good about honoring there warranty on the blowers which is quite long, Might be lifetime not
Electronics Forum | Tue Apr 05 16:20:49 EDT 2011 | cvoyles
I work with a small EMS shop that has extremely good capability because I created it for an R&D Lab for the U.S. Army. We have at times discussed leasing the equipment/facility to other companies who prefer that to farming out their work to an EMS.
1 |
Reflow ovens for automated SMT PCB assembly, specializing in lead free processing and nitrogen reflow. The best convection reflow ovens on the market.
4 Vreeland Rd.
Florham Park, NJ USA
Phone: 973-377-6800