Electronics Forum | Mon Nov 29 18:23:19 EST 2010 | comprep
Has anyone had any success with placing BGAs with the Quad QSP-2? We have been having alignment issues with BGA placement but our placement of 0402 parts is dead on. We have worked through the calibration and it seems to be correct.
Electronics Forum | Thu Jun 12 10:55:02 EDT 2014 | lightinguk
Hi can some tell me how the setup the rt computer on the quad qsp2 , rt computer is not talking to the qsoft computer has anyone got any ideas ?
Electronics Forum | Wed Jun 30 21:27:15 EDT 2010 | comprep
I need some info on a xp upgrade for a quad qsp2 dose it have aney binifit over win 98.
Electronics Forum | Thu Jun 12 11:04:48 EDT 2014 | bobpan
You could have a bad hard drive or the bios settings could be incorrect. We also need to find out what motherboard version you have. Please e-mail me for further help. Go to: www.precision-repairs.com and my e-mail address is on the site. Bob
Electronics Forum | Tue Nov 30 06:33:44 EST 2010 | jmw
If you are using the upward camera then you probably have to put in a placement offset for each head. This only effects upward camera placements...not quadalign. This is located in: 1. machine-calibration-camera lens 2. Choose upward camera2 under "
Electronics Forum | Wed Feb 23 15:19:49 EST 2005 | Dilbert
I don't work on quads but I can give you some things to look for... Each of the moving axis work off a motor that is controlled by a "drive". Some of these drives have a fault or error output that is connected to the motion controller. One of your
Electronics Forum | Thu Jun 06 09:03:48 EDT 2019 | bobpan
If the part is 10mm or less as long as you are scanning it near the top...it should work. The other possible problem is dirt on the quadalign lens. Clean off the lens and watch it when it homes....both heads should home the same way. If the head jum
Electronics Forum | Wed Nov 07 20:20:58 EST 2018 | bbqstorm
Looking for all manuals and training info available for a Quad qsp-2 thanks
Electronics Forum | Mon Jun 22 11:19:26 EDT 2009 | phase1
We are looking for an individual who knows how to operate and program a Quad QSP2 machine. We are located in Rockville Maryland. Machine was bought at an auction some time ago and we need it up and running. Payment can be discussed with David. 301 27
Electronics Forum | Wed Mar 05 14:03:12 EST 2014 | jhamlet
We have a Quad QSP-2 that recently started moving the gantries around incredibly fast and erratic at random times, but always while placing on a board. Any help would be appreciated. Thanks.