Electronics Forum | Thu Jul 20 14:44:26 EDT 2000 | Bob Willis
If you are getting skips on these parts the most common reason for skips is gassing and wave too low. I would agree that wave soldering these parts is not ideal. If the shorts are always in the same location on one or two pins a glue dot done during
Electronics Forum | Fri Jul 04 19:17:37 EDT 2014 | andrespena
Hi (I don't know if this forum is the best place to post something like this, but I don't know of other places on the internet, so... sorry if I'm in the wrong place) Might there be an easier way to add components (e.g. computer chips) to a circuit
Electronics Forum | Fri Nov 30 08:35:51 EST 2007 | stepheniii
We put glue on the bottom of the board that already has the topside SMT mounted. We populate the board. We put it through a cure profile. At this stage the topside components are soldered on. The bottom side components are glued on with NO solder on
Electronics Forum | Mon Apr 01 12:07:25 EST 2002 | slthomas
* What material are you using? Loctite 3609 * What is your cure profile? In excess of the 90-120 seconds at 150C that Loctite recommends. * Dot dimensions and tip? 27g. conical tipped needle for the 0603's. I started with a 14 mil dot which loo
Electronics Forum | Mon Jun 29 15:33:28 EDT 2020 | jmelson
WOW, thanks for the documents, this will REALLY help selection. It looks like I want the FLX2011CV, that makes it a lot easier to set up and not have to reach into the machine to load and unload boards. The machine footprint is really compact, 10 m
Electronics Forum | Fri Jul 01 18:00:44 EDT 2005 | mrduckmann2000
RB, We have a gold finger problem here at our plant. Our kapton tape came off in the wave process and now we have 8 PCB's that have silver fingers. We are waiting on our new A.P.E. SRS-069 Gold Finger Plater. This mircle machine is going to fix a
Electronics Forum | Thu May 27 19:00:37 EDT 2010 | emrtech
not just speed, looking to reduce down time on having to re-do boards from bad stencil screening. also, the accuracy of placing solder paste down on PCB's. why would you want an employee spending so much time aligning fiducial marks from panel to pan
Electronics Forum | Wed Jul 24 22:24:07 EDT 2013 | mac5
When we first got our XP1’s the cycle steal was on a schedule. We would have boards running good and then start placing off in the middle of a run. We finally noticed that the cycle steal had run just prior to the parts being misplaced. We have turne
Electronics Forum | Fri May 02 00:22:15 EDT 2008 | deni
Hi everyone, I am an Electrical Engineer (BT). I am interested to start my own business on building up electronic boards (thru-hole and SMT). I have never done this work before except practice in college. My questions are: 1. What is the future sta
Electronics Forum | Fri May 02 08:43:48 EDT 2008 | chineechooze
I am Indian and a guru in industry so let me answer questions one by one 1. What is the future status on thru-hole boars, are they going to stay for long time on a market? TRU-HOLE MAKING A BIG COME BACK. THEY COME IN THE LEADFREE NOW. 2. Which
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411