Industry Directory | Manufacturer
Tape and Reel and Lead Trimming. One stop source for manual pick and place machines, automatic pick and place systems, manual and automatic taping systems, and mass lead trimming equipment.
Industry Directory | Consultant / Service Provider / Distributor / Manufacturer
For over 30 years, V-TEK International has been a global leader in the electronic component packaging and processing industry by providing cost-effective component packaging and processing options with fast return on investment.
Form & Cut 2-, 3-, 4-, 5-, and 7-leaded Radial Components Capable of forming loose radial components at rates up to 5,000 parts per hour with a variable speed motor. Feed components by hand or with tubes (TO-220s) Reduce setup time with quick ch
KSUN R05 JUKI Feeder Calibration It is essential for this equipment that enhanced productivity , installation and quality improvement As the high efficiency vision camera is asked in order to investigate precisely and repair the error of device pos
Electronics Forum | Thu Dec 15 07:15:22 EST 2005 | stefwitt
After re-reading your posting, Liza, I�m doing yet another correction to my reply. Are you using the same taping machine for all your components or could you narrow it down to one taping machine? Is it a fully automated taping process or more likely
Electronics Forum | Wed Dec 13 12:08:57 EST 2000 | Stefan Witte
Apparently the adhesive tape peels off from the joint, which could have some reasons. 1. There should be an overlap of the cover tape, as Cal mentioned. The new cover tape laying over the old by approx. 2mm. I also peel the cover tape a bit off, whi
Used SMT Equipment | Tape and Reel
Function Automatic splicing machine can connect multi-material tapes of the same specifications, automatic detection, precise cutting, automatic docking, wrapping with plastic film and automatically receive material after con
Used SMT Equipment | THT Equipment
Cycle Rate Max 25,000 cph (0.14 sec. per insertion) Reliability 200 ppm or better Component Types Capacitors, resistors, diodes, jumper wire, etc. Component Specs Component Class I Distance Between Tapes 52.4mm +/- 1.5mm (2.063” +/- 0.059”) Pit
Industry News | 2019-01-09 21:58:38.0
GPD Global will exhibit at IPC APEX EXPO 2019. Stop by Booth 2915 to see live demonstrations of machines and equipment. Experts will be there to discuss your production needs. Whether your project requires a pump for retrofitting or a fully automated dispense system, conformal coating, or component preparation, we have a solution for you.
Industry News | 2017-11-07 23:20:25.0
GPD Global offers a cost-effective, automated Conformal Coating System (SimpleCoat) with excellent repeatability for just under $40,000!!!
Parts & Supplies | Pick and Place/Feeders
GIC-R05 JUKI Feeder Calibration JIG It is essential for this equipment that enhanced productivity , installation and quality improvement As the high efficiency vision camera is asked in order to investigate precisely and repair the error of devic
Parts & Supplies | Pick and Place/Feeders
GIC-K02 KME CM88 Feeder Calibration JIG It is essential for this equipment that enhanced productivity , installation and quality improvement As the high efficiency vision camera is asked in order to investigate precisely and repair the error of d
http://www.gpd-global.com Conformal coating (SimpleCoat) demonstration of the Spray Valve and Volumetric Pump in action on the SimpleCoat system. The Spray Valve sprays HumiSeal 1B31 from a height of approximately 20 mm above the board. The Volumetr
http://www.gpd-global.com No drip no drool across a wide range of fluid viscosities (low-to-mid and low-to-high). No manual adjustment to compensate for pump variability. Truly Volumetric PCD Pumps for total control of dispensing fluids. Ability to
Career Center | Vestal, New York USA | Engineering,Research and Development
Experienced Sr./Principal Software Engineer and Systems Analyst in various applications, especially embedded real time systems and device drivers and board support including 80x86, Power PC, Motorola 68K, TI DSPs and a number of other platforms using
Career Center | NEW DELHI, India | Technical Support
I am having almost 20 years of experience in the field of electronics repairs domestic & industrial, able to work on any circuit and PCB without any schematic or diagram. I have all the records and certifications with me and fully c
GPD Global | https://www.gpd-global.com/co_website/pdf/coating/SimpleCoat-Operation-Guide-23100600.pdf
SimpleCoat Operation Manual SimpleCoat Operation Manual PN 23100600 for use with SimpleCoat Software version 2.10.18 on SimpleCoat (PN 23100005-0001) & SimpleCoat TR (PN 23100005-0002) GPD Global® Documentation Department GPD Global
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/industrial-coating-systems/additional-product-sub-type/manual-powder-systems?con=t&page=13
Manual Powder Coating Spray Systems | Nordson Industrial Coating Systems Corporate | Global Directory | Languages Division Only All of Nordson Application Solutions Powder Coating Liquid Painting Container Coating Sealant Adhesive Systems Automotive Assembly UV Curing Systems Industries Aerospace Agriculture
