Electronics Forum | Tue Oct 23 09:21:44 EDT 2018 | bobpan
What files should we backup in case of a hard drive failure on the momentum printer? Software is 3.6.1. Thanks
Electronics Forum | Thu Apr 26 13:16:28 EDT 2018 | bobpan
I am trying to figure out how to teach the position of the tooling so that its aligned to the hole in the worknest. In other words...the carousel is out of position. When i go into machine calibration and i step through it the process freezes at a st
Electronics Forum | Fri Dec 14 19:56:40 EST 2018 | denisss
Good afternoon, the problem gives an error vision gantry x, an error occurs after the camera approaches the car wash and hits the piston, what could be the matter? are there any real specialists gives an error after a certain working time of 40 minut
Electronics Forum | Wed May 13 15:26:45 EDT 2015 | cyber_wolf
We are high mix - high changeover aerospace manufacturer. We have 3 1809 MK3 air ovens. There has been absolutely no issues with them. We have 4 MPM Momentums. I looked at DEK but felt the MPM's were put together better. They are very easy to use
Electronics Forum | Tue Nov 25 12:48:31 EST 2014 | cyber_wolf
Has anyone looked at SPI results across different squeegee blade manufacturers ? We are running Momentums and using the MPM pro-blades. Ive been considering looking at permalex blades again to see if I can maybe squeek out some better yields.
Electronics Forum | Thu Feb 15 13:46:16 EST 2018 | aemery
Griinder, Maybe it's me, but I think what you might be saying here is that you see a reflected image of the PCB or Stencil when you and teaching the fiducials and it is interfering with the teaching routine, is that correct? If this is true it is c
Electronics Forum | Wed Mar 07 13:48:29 EST 2018 | griinder
I have some questions concerning 2d inspection on the momentum. Perhaps I'll start a new thread.
Electronics Forum | Mon Feb 12 13:09:52 EST 2018 | griinder
I see. As you say, Fid coordinates or good measurements should make it easier. 2d inspection setup at the machine may be a little more difficult. Thank you for the clarification. The Momentum's Vision is not inverted, it displays as if you are lookin
Electronics Forum | Tue Mar 06 06:58:29 EST 2018 | griinder
Thank you guys for your help and detailed explanations. I have successfully been able to teach pads as fids. The camera view is very annoying, but manageable. Especially when teaching inspection positions. On the momentum's we can use Gerber EZ Teac
Electronics Forum | Wed Mar 07 12:57:55 EST 2018 | aemery
Gerber EZ is not available on the Accuflex platform. Speedline (now ITW EAE), like most manufactures, do not want to offer new tools on old platforms. There is one feature in the AccuPro software that I don't believe was added in any version of the