Electronics Forum | Wed May 13 15:26:45 EDT 2015 | cyber_wolf
We are high mix - high changeover aerospace manufacturer. We have 3 1809 MK3 air ovens. There has been absolutely no issues with them. We have 4 MPM Momentums. I looked at DEK but felt the MPM's were put together better. They are very easy to use
Electronics Forum | Tue Nov 25 12:48:31 EST 2014 | cyber_wolf
Has anyone looked at SPI results across different squeegee blade manufacturers ? We are running Momentums and using the MPM pro-blades. Ive been considering looking at permalex blades again to see if I can maybe squeek out some better yields.
Electronics Forum | Thu Feb 15 13:46:16 EST 2018 | aemery
Griinder, Maybe it's me, but I think what you might be saying here is that you see a reflected image of the PCB or Stencil when you and teaching the fiducials and it is interfering with the teaching routine, is that correct? If this is true it is c
Electronics Forum | Mon Feb 12 13:09:52 EST 2018 | griinder
I see. As you say, Fid coordinates or good measurements should make it easier. 2d inspection setup at the machine may be a little more difficult. Thank you for the clarification. The Momentum's Vision is not inverted, it displays as if you are lookin
Electronics Forum | Wed Mar 07 13:48:29 EST 2018 | griinder
I have some questions concerning 2d inspection on the momentum. Perhaps I'll start a new thread.
Electronics Forum | Tue Mar 06 06:58:29 EST 2018 | griinder
Thank you guys for your help and detailed explanations. I have successfully been able to teach pads as fids. The camera view is very annoying, but manageable. Especially when teaching inspection positions. On the momentum's we can use Gerber EZ Teac
Electronics Forum | Wed Mar 07 12:57:55 EST 2018 | aemery
Gerber EZ is not available on the Accuflex platform. Speedline (now ITW EAE), like most manufactures, do not want to offer new tools on old platforms. There is one feature in the AccuPro software that I don't believe was added in any version of the
Electronics Forum | Fri Oct 05 08:35:29 EDT 2001 | PeteC
I believe this machine is now the MPM UP 100 and is supported thru Speedline Technologies-MPM and is now mfg.'d in Franklin Mass.
Electronics Forum | Tue Sep 13 02:31:50 EDT 2016 | bukas
board input sensor sensitivity? maybe conveyor movement triggers it and because of that it sends pulse. conveyor moves few millimeters, how does machine act?
Electronics Forum | Tue Sep 13 07:32:51 EDT 2016 | bukas
that sounds like bad relay or relay control. are you in position to check it on relay pins? I would go from there.