Electronics Forum | Fri Mar 23 07:55:20 EDT 2018 | cyber_wolf
The shafts are not going to origin during zero set. Take a look at your station 12 sensors and fiber units.
Electronics Forum | Thu Apr 28 08:12:39 EDT 2005 | PL
My company is just starting run 0402 component but the 0402 component giving lot of reject example overturn and pickup miss error so anyone know how to soft this problem Machine Type:-Pansert MV2F 1)machine already inspection 2)already test new f
Electronics Forum | Thu Apr 28 15:56:44 EDT 2005 | stepheniii
Hopefully it is just the part data a little bit off. But if that doesn't help, make sure the thickness sensor is calibrated bang on. And do the nozzle height adjustment. What are your nozzles and filters like, as far as being clean goes? I've put dow
Electronics Forum | Tue Sep 15 19:23:18 EDT 1998 | Jimmy Strain
| I am thinking of purchasing a Panasonic MV series chipshooter. If you own a Panasonic MV machine I would like to hear what you like and dislike about it. Is the service good? Are spare parts readily availiable? Does Panasonic support and follow up
Electronics Forum | Sun Mar 12 13:09:33 EST 2000 | Jeff Wilson
Jeff, The problem you are describing MAY be related to the push up pin setting on your component feeder units. Please verify that the push up pin height is set correctly for the feeder units, and the nozzle pick-up and placement heights are to the c
Electronics Forum | Sun Mar 12 13:09:33 EST 2000 | Jeff Wilson
Jeff, The problem you are describing MAY be related to the push up pin setting on your component feeder units. Please verify that the push up pin height is set correctly for the feeder units, and the nozzle pick-up and placement heights are to the c
Electronics Forum | Wed Dec 06 22:56:50 EST 2000 | Brad Kendall
Steve, Metcal can still provide some of these nozzles. I represent Metcal in Michigan and have a few customers still using the FCR system. They have purchased some new nozzles, but I also have an old demo unit with a large assortment of demo nozzle
Electronics Forum | Wed Dec 06 22:57:23 EST 2000 | Brad Kendall
Steve, Metcal can still provide some of these nozzles. I represent Metcal in Michigan and have a few customers still using the FCR system. They have purchased some new nozzles, but I also have an old demo unit with a large assortment of demo nozzle
Electronics Forum | Mon Nov 10 23:20:55 EST 2008 | stanyserrao
Light Units are replaced with new if the problem > of lights then it will not vision process the > nozzle center measrement and resolution Jigs > too.. > > Jig is meauring in trace mode and > identifiying all leads which are fine > fitch. > >
Electronics Forum | Wed May 30 18:05:02 EDT 2007 | fredc
Chunks, Nozzle unfriendly? Maybe it should be called nozzle hostile. Depending on the machine and lighting a nozzle with a 1.8mm tube might work. In English units that would be a .072 OD with a .062 ID. The area such a nozzle would pick from is the 6