Electronics Forum | Sun Feb 10 16:04:28 EST 2013 | marcelorotofrance
Recently I posted a query about my Quad IVc align problem. At the same time, I am working with the feeders we have received with the machine. These are from different origins and antiquity. Some are faster than others. The slower ones have discrete t
Electronics Forum | Thu Sep 23 11:28:57 EDT 2004 | Frank
We have placed labels using the Hover-Davis label feeders on our Juki machines and we used standard nozzles. Are your labels an odd shape where a standard nozzle won't work?
Electronics Forum | Thu Sep 23 11:50:54 EDT 2004 | JB
We are using a standard nozzle Once placed, the label is not flat, the ends of the label are slightly lifted on both ends. The label is .650 x .200 Have you guys run into a similar problem?
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Tue May 06 09:38:41 EDT 2003 | blnorman
We use both labels and lasers to mark our boards. Since implementing the lasers, the downtime attributed to bar code labels on those lines have dropped to virtually nothing. We still have problems with the labels wrinkling during reflow making read
Electronics Forum | Thu Sep 23 10:28:33 EDT 2004 | JB
We are placing labels using a Hoover-Davis feeder with a GSM. Anybody else out there doing this? My question is: Are you using a special nozzle for this operation?
Electronics Forum | Tue Sep 28 12:44:30 EDT 2004 | JB
You are right, basically our options are down to a custom nozzle. Pushing down the label is not the route that I would go with. Thanks for your input and good to hear that you guys found a way around it.
Electronics Forum | Fri Sep 24 12:02:57 EDT 2004 | Frank
Yes, I can see your problem, the nozzle makes only good contact in the center and so the ends don't make good contact. The ends tend to curl up during reflow. There were two suggestions to solve this. 1) Let the operator push down the labels befor
Electronics Forum | Wed Dec 06 23:12:09 EST 2000 | Brad
Chris, Have you considered Fuji? The robustness of Fuji is proven. I have recently done floor space analysis and cost per placement/sqr foot studies. I have also performed ROI studies on these machines. The new CP7 machine from Fuji outperforms th
Electronics Forum | Fri May 31 16:26:22 EDT 2002 | Feederman
Steve, you might want to check out the pre-printed and print-on-demand label feeders that are available through Hover-Davis. These types of feeder remove the potential human placement errors which sometimes occur. The feeders are available for most p
