Electronics Forum | Sun May 16 00:07:58 EDT 2010 | tpappano
I have a Philips CSM84VZ. There are offset calibrations that compensate the X and Y distances from the camera to the heads and the beam pointer. Perhaps yours is similar and just needs a small Y adjustment for the beam pointer.
Electronics Forum | Wed Jun 29 13:24:16 EDT 2005 | haviland
Can anyone provide the corresponding Yamaha model numbers for the old Philips CSM84 & CSM 84 VZ machines? Thanks.
Used SMT Equipment | SMT Equipment
Looking for spare parts and specially feeders (8, 12, 16, gravity, electric, neumatic, etc)
Used SMT Equipment | Pick and Place/Feeders
We have more Philips CSM feeder 8x4mm, 12mm, 16mm, 24mm, 32mm and gravity feeder, good condition, good price.
Parts & Supplies | Chipshooters / Chip Mounters
Looking for parts to fit Philips/Assembleon CSM46/60. Chucks, belts, etc. We do not need feeders.
Parts & Supplies | Chipshooters / Chip Mounters
Below philips assembleon smt belts are manufactured in China,so no need to describe too much about price,what's the difference is that you will surely like it when you try them on machines,just based on the proved quality,please contact louis@smt-mac
Career Center | Dargaha Road Zameen Pallavaram Chennai, Tamilnadu India | Maintenance,Technical Support
CURRENT JOB: • Responsible for four sub department as Production support, Preventive maintenance activity, Spare parts control and NPI (New product Introduction) under one Equipment department. • Take care of OEE (Overall Equipment Efficiency), MTTR
Career Center | , | Engineering,Production,Quality Control
SMT EXPERT WITH DOE ,DFM AND LEAN SKILLS
winsouce.jpg)
