Electronics Forum | Tue Mar 04 10:32:31 EST 2008 | tegel
Hi, Do you know if there is any standard that specify that a component manufacturer shall mark a BGA component in the corner where you have the ball A1? Best Regards, Lars
Electronics Forum | Wed Mar 05 14:13:17 EST 2008 | dphilbrick
Interesting. We are placing a camera that the marking is on the bottom..... No place to put it on top! The problem with the question is the word shall! I think the answer to the question is yes there is a standard but..... no law to enforce it....jus
Electronics Forum | Tue Mar 04 20:47:48 EST 2008 | davef
Available on the web, JEDEC PUBLICATION 95, DESIGN GUIDE 4.14, Ball Grid Array Package (BGA), Figure 4.14-3, Note 10: A1 corner must be identified by chamfer, ink, mark, metalized markings, indentation or other feature of package body, lid or integra
Electronics Forum | Fri Nov 08 05:40:54 EST 2019 | leeg
We place these on a few boards and have no issues with reflow or warpage. How thick is your PCB?
Electronics Forum | Wed Sep 15 10:59:12 EDT 2010 | asksmt
Thanks for the valueable feedback, I have two questions 1. why do you have to extend the pad size ? is it okay if i keep pad size 2. I am currently using thermal pad size recommended in datasheet max value 4.2mm x 4.2mm, how much should i shrink
Electronics Forum | Tue Jul 20 06:36:24 EDT 1999 | Badia
First of all, I'm a young Spanish so sorry for my English I'm looking for a smd single pin connector. I need it to solder it in a alumina's substrate. Please. can anybody help me ?
Electronics Forum | Mon Jul 26 13:39:26 EDT 1999 | Badia
Despite the goodness of Dave F. and George Verboven, I was unable to find the damned single pin connector. As a last attempt, I've draw it (see the link) If somebody knows where can buy it, please help me (and sorry for to ruin the English language
Electronics Forum | Tue Sep 01 11:46:09 EDT 2009 | andoe
when the cp6 loads a board everything seems normal / as the table drops the pcb lines up onto the origan hole and then instantly fails with -- "original pin error" we have run this board before. any ideas? thanks
Electronics Forum | Thu Nov 07 21:28:31 EST 2019 | sssamw
The connector is so long, and has big metal parts, it will be little deformed during reflow I guess, andthe pins planarity should be critical for 200 pins. Did you measure the non wetting pins profile to see if temperature ok? And maybe you can try u
Electronics Forum | Thu Sep 17 03:32:31 EDT 1998 | Thomas Blesinger
can anyone help with information about I-shape of SMDs. our Design includes this shape of contacts. we are searching for information on quality judgement of solder joints with I-leads on Pads. Please help.