Electronics Forum | Sat Jul 31 23:17:48 EDT 2004 | Bryan Sherh
Hi,Please 1.X-ray your board where you found pinholes.perhaps you'll found much voids in your joints,but not only the pinhole.this must be caused by the poor solderability of PCB mostly...or components. 2.Cross-section the pin hole or void in the joi
Electronics Forum | Mon Aug 09 16:37:14 EDT 1999 | John Thorup
| Just curious what effect pinholes and solder voids can have on solder joints that have high current passing thru them. Also could moisture from steam sterilization (autoclaving) get inside a said solder joint and then outgas during high current, an
Industry News | 2003-06-10 08:16:44.0
The following text describes the application of NWA Quality Analyst to quality control in the assembly of electronic components.
Industry News | 2017-05-01 15:08:27.0
Specialty Coating Systems (SCS) is pleased to announce that it will participate in a Mechanical Engineering-sponsored webinar on Thursday, May 18, 2017 at 2 p.m. EDT. The webinar, entitled, “Parylene Conformal Coatings: Increasing the Reliability of Complex Technologies,” will be presented by SCS’ Dick Molin, Sr. Medical Market Specialist and Dustin England, Sr. Polymer Chemist. The webinar is now open for registration at: scswebinars.com.