Electronics Forum | Mon Jun 20 18:36:42 EDT 2005 | jsloot
Does anyone have any experience with a QUAD Meridian 1010? Our company has purchased a used machine. We have it installed and running almost smoothly. Getting an error code 3487, description is "Z axis target position in motion board is strange" Anyo
Electronics Forum | Thu May 20 09:47:25 EDT 2010 | pforister
Is this a single head Quad IVc or a dual headed line? if it is a dual line you can swap the align cards in the front bay between the two heads and see if the symptom follows. The card on the far right is a transport card, shouldn't need to swap tha
Electronics Forum | Mon Apr 11 06:54:03 EDT 2011 | mosborne1
Wipe off your linear scales and clean your quadalign lense.
Electronics Forum | Sat Feb 02 04:48:30 EST 2019 | dfl
yes it's moving at the wrong pitch, about 3 components a time. Is the programming you talking about at the microcontroller AT85C55 or that serial memory 24C04? Or there is some procedure on the Quad to adjust this?
Electronics Forum | Tue Apr 19 14:58:05 EDT 2011 | rdoss
The ribbon cable would be my guess. I ran a IVc for about 3 years and we use to have to change out our cable at least once per year. I also wanted to add that you can contact Precision Placement Machines (PPM) for parts and service. We use to use
Electronics Forum | Fri Feb 01 18:23:30 EST 2019 | slthomas
Is it indexing at the correct pitch when you push the forward button? I really can't remember much about those machines but it seems like that's an indication that it's not programmed correctly. I'll be bobpan knows, regardless. ;)
Electronics Forum | Sun Feb 03 07:41:29 EST 2019 | dfl
Anyway, after both procedures, the feeder still advancing more than 4mm (like 12mm or so)
Electronics Forum | Fri Apr 08 21:39:17 EDT 2011 | jimlas53
Hi, We have a Quad IVc set up with all picks, placements, and sequence working. I have managed to get through several passes with some pain, mainly from SOT-23 parts, but it is getting better. On occasion, when picking from one of three feeders loc
Electronics Forum | Mon Apr 11 15:57:25 EDT 2011 | bobpan
If the feeders that you are having problems with have tall parts in them.....and these are the ones the machine is stopping on.....check to see that you are not scanning higher than what your function 30 nozzle height is. In other words...if your fun
Electronics Forum | Sun Feb 03 08:46:34 EST 2019 | dfl
SOLVED The LED/phototransistor was a little of the center on the "index wheel" (don't know a better name, its the gear that pulls the component strip). The wheel works with a LED from one side and a phototransistor from the other, through a hole on
