Electronics Forum | Mon Sep 08 10:32:39 EDT 2014 | nhel_0009
Right sir we already fix it by loading configuration from other machine
Electronics Forum | Fri Dec 15 01:37:21 EST 2006 | shrikant_borkar
Hi, Hemendra Recently, We have carried out lead Free Soldering On our 4+1 Panasonic Reflow machine. Results were fine , but its Not Recommended for long Run. but the machine which you have is 5 zone machine and additional 2 cooling zone too. Check
Electronics Forum | Tue Feb 14 03:58:17 EST 2006 | Rob
Yes, it's fine - as Pete says you have to replace certain parts & either get the pot recoated or a new one. We ran a "Lead free" 6622C from Vitronics Soltec on Tin Lead, then it was cleaned up, recoated and loaded with a no-lead alloy with no proble
Electronics Forum | Fri Dec 10 11:22:50 EST 2004 | rlackey
Hi, We paid �60K for a 6622C from Vitronics Soltec, no idea about US costs since the dollar went down the swanny. Great machine though. Not all lead free ovens come with Nitrogen capability - it depends whether you specify it or not, and it can ad
Electronics Forum | Thu Dec 09 04:32:56 EST 2004 | chad
I'm currently using Electrovert Vectra's right now. They do really well. I was actually in New Hampshire last month looking at Vitronics Soltec's newest wave soldering machine too. I think they would be worth a look as well. Good Luck!
Electronics Forum | Wed Jun 02 09:10:30 EDT 2004 | dougm
My company is looking at the various options for selective soldering machines. We are mostly a low volume, high mix facility, with some moderate volume orders as well. I have looked at the Pillarhouse Topaz XL, Ersa Versaflow, and Vitronics Soltec
Electronics Forum | Mon May 09 15:56:25 EDT 2005 | dougm
We are a high mix/low volume shop (avg. lot size is about 60). Hand solder was a bottleneck, so we looked into selective machines. We purchased a Vitronics-Soltec mySelective and are very happy with it so far. Although it has a large footprint, ev
Electronics Forum | Sun Mar 28 22:17:36 EST 2004 | Grant Petty
Hi, I would also be interested in this thread, but our problem has a different twist to it. We have good results from our reflow with Koki no clean paste, however when we pass the boards through the wave solder machine, the flux in that leaves a fog
Electronics Forum | Sun May 23 07:13:56 EDT 1999 | Scott Cook
| Has anyone had any experience or data using vibration during the reflow process. | We introduced a vibration device attached to the fixed rail on a Vitronics reflow oven. The reason was to prevent skewing on large PLCC devices. The process worked v
Electronics Forum | Thu May 28 09:23:59 EDT 1998 | Chrys
| Hello, | | I need some users information about "hot air knife" after the wave | bath: | - Defects reduction ? | - In what kind of boards(TH/SMT SOICS ect.) it is applied ? | - Where can I purchase it as a retrofit (Soltec Delta 6622cc) ? |