Electronics Forum | Fri Apr 23 10:53:24 EDT 2010 | evertonsanches
Hello Sir, in this situation I recommend you to check and reconect the conectors of Quad Align Board and also of Quad Align Sensor. Everton - Brasil
Electronics Forum | Wed Jan 23 11:28:47 EST 2008 | tbkonrad
Help! Since last Friday i have been having issues with a Quad qsv-1, it all started with a quad align error, i found there to be a small quantity of grease covering the lenses on both quad align sensors. I wiped the grease off and then everything s
Electronics Forum | Tue Sep 15 13:20:02 EDT 1998 | Jim Mitchell
Quad Systems sells the Samsung product with Quad's patented QuadAlign optics system and Quad feeders as opposed to the mechanical centering system available on the product direct from Samsung. Generally, all optical centering is superior to mechanic
Electronics Forum | Fri Jun 28 13:02:48 EDT 2013 | Dennis
Chris, I sent an email requesting the price on a P4 Quad Align sensor. It is the one we are looking for. If it's quicker you can provide the price that will work as well. Just wondering, where are you guys located. Thank You,
Electronics Forum | Sun Feb 10 15:14:25 EST 2013 | marcelorotofrance
After an in depth examination, I found that the problem was not a defective connector as I thought in the first place. Actually is a broken through-hole on the Quad Align sensor. I requested a spare part to PPM. Mr. Bobpan, thank you again.
Electronics Forum | Mon Jan 30 13:19:37 EST 2012 | deanm
Now knowing that its a Quad, I'm assuming it has QuadAlign which spins the part it just picked in a beam of light and a sensor measures the length, width and height of each part. If it falls outside of a defined range, it will throw it in the dump bi
Electronics Forum | Wed Feb 11 11:12:23 EST 2015 | daniel_esposito
Thank you Bobpan! I checked the laser sensor and could see through the glass a small stripe (dash)in the inside lens, just in the middle of it. Thank you again.
Electronics Forum | Fri Dec 09 14:37:04 EST 2005 | derengmao
I am using ver 6.50 software. Do you know Quad Align compared to Cyber or Samsung's own, which is better? Do you know if the QSA30V support non-symatrical Micro-BGA such as DDR2 DRAM IC?
Electronics Forum | Fri Jan 03 15:16:54 EST 2014 | ppminc
If all of the lights are on, on the operator interface panel usually that means the EPCU is defective or not fully seated correctly. If you swapped out the EPCU board from another machine you need to make sure its the same type of machine. If it has
Electronics Forum | Mon Mar 14 08:35:27 EST 2005 | ???
no...its losing its position and it homes ok so the sensor is not the problem.....there is a mod code that sets the illumination level for the quad align....make sure that is at 200 or higher. You may want to change the qa card if you have another on
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
